Skip to content

RFC ARM: Kirkwood: Synology DT files

Andrew Lunn linux-arm-kernel linux-devicetree 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest0 of 2 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 2 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH RFC RFT 0/2] ARM: Kirkwood: Synology DT files
Quoted 8 lines · Ben Peddell
Quoted 5 lines · Andrew Lunn

Request for Testing:

This patch adds support for around 30 different boards. Most .dts files support a couple of different models. I don't have any of this hardware. None of this is tested.

Tested by Ben Peddell <[email protected]> (specifically kirkwood-ds210.dts on DS211j)

Hi Ben

Thanks for testing. I will fix the gpo and send a v2 sometime. I should also check if there are any more gpo's i have as gpio's.

Quoted 10 lines

To get running on the stock bootloader, I needed to extend the initramfs to fill the entire rd.gz flash partition, configure the kernel to use the dtb appended to it, configure it to ignore the information passed to it by the bootloader, and add the following nodes to the dts:

/chosen {
	linux,initrd-start = <0x800040>;
	linux,initrd-end   = <0x940000>;
};

Do you know why these initrd properties are needed? There is only one other board in mainline that requires this. I also wonder what implications this has. u-boot has the capability of reading the initrd from disc to RAM and passing its location to the kernel. By hard coding these values, are we blocking that?

Thanks
Andrew