Skip to content

ARM: mvebu: Use Hardware BCH ECC for RN104 and RN2120

Jason Cooper linux-arm-kernel linux-devicetree linux-mtd 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 2 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 2 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/2] ARM: mvebu: Use Hardware BCH ECC for RN104 and RN2120
Quoted 15 lines · Arnaud Ebalard

Hi,

Following Ben's report and fix for RN102, I did some tests on RN104 and RN2120 (they have the same Hynix H27U1G8F2BTR flash and setup) and came up w/ the exact same fixes for their respective .dts files. With those patches, it is now possible to update kernel from userland and u-boot will happily load and boot it on those devices.

Both patches should be candidates for stable, I guess.

Cheers,

a+

Quoted 7 lines

Arnaud Ebalard (2):
ARM: mvebu: Netgear RN104: Use Hardware BCH ECC
ARM: mvebu: Netgear RN2120: Use Hardware BCH ECC

 arch/arm/boot/dts/armada-370-netgear-rn104.dts | 4 ++++
 arch/arm/boot/dts/armada-xp-netgear-rn2120.dts | 4 ++++
 2 files changed, 8 insertions(+)

I've applied both patches to mvebu/fixes and flagged them for stable, v3.14+. I removed the 'Depends' line from each, as Thomas mentioned, there is no build dependency between these dts changes and the code supporting it (as it should be).

thx,

Jason.