Skip to content

usb: dfu: am335x: allow dfu in fullspeed mode only

Lukasz Majewski u-boot 1 version New

Get series with b4
b4 am 20140909162408.5847517e@amdc2363

Versions newest first

  1. v1 Latest1 of 2 patches 0 repliesNew

1 of 2 patches is in this archive. The cover letter announces 2.

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/2usb: dfu: add config option to use in dfu mode fullspeed only+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH v1 0/2] usb: dfu: am335x: allow dfu in fullspeed mode only

Hi Bin,

Quoted 13 lines

Lukasz,

Quoted 7 lines · Lukasz Majewski

Hi Heiko,

Quoted 1 line

This patchserie adds the new config option CONFIG_DFU_FULLSPEED.

Is there any special reason to support Full Speed (12 Mbit/sec - USB 1.1) and not rely solely on the High Speed (USB 2.0) as we do now?

The drivers must support full-speed anyway based on the USB2.0 Specs.

Quoted 8 lines

I have seen many cases in which only full-speed is suitable due to either board design or specific USB use case.

One example is that to better fit to the production firmware flashing automation, a board does not use standard USB receptacle or plug, but a four touch pads on the PCB, so that the robot can grab the board and touch the pads to download the firmware. In this case signal integrity is a concern, but not download speed.

Thanks for example.

Best regards,
Lukasz

Quoted 36 lines

Regards,
-Bin.

Quoted 31 lines
Quoted 2 lines

If this is enabled DFU uses fullspeed only. This is used on the siemens boards.

Is there any DFU problem with the mentioned Siemens board, that we must use USB 1.1?

I'd also appreciate more verbose rationale for this patch series - why this change is needed? What is the expected improvement?

Thanks in advance.

Quoted 17 lines
Cc Tom Rini <[email protected]>
Cc Lukasz Majewski <[email protected]>
Cc Marek Vasut <[email protected]>
Cc Liu Bin <[email protected]>
Cc Lukas Stockmann <[email protected]>

Heiko Schocher (2):
usb: dfu: add config option to use in dfu mode fullspeed only
arm: am335x: siemens board use in DFU mode fullspeed only

  README                                 | 3 +++
  drivers/usb/gadget/f_dfu.c             | 3 +++
  drivers/usb/gadget/g_dnl.c             | 3 +++
  include/configs/siemens-am33x-common.h | 3 ++-
  4 files changed, 11 insertions(+), 1 deletion(-)
Signature · 5 lines
Best regards,

Lukasz Majewski

Samsung R&D Institute Poland (SRPOL) | Linux Platform Group