spl: MMC U-Boot image load from raw partition
Get series with b4
b4 am 20141113121601.7177bdb4@lilithVersions newest first
- v1 Latest0 of 2 patches 0 repliesNew
Patches in v1 No applies recorded yet
None of the 2 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [U-Boot] [PATCH 0/2] spl: MMC U-Boot image load from raw partition
Hello Tom,
Quoted 17 lines · Tom Rini
Quoted 8 lines · Albert ARIBAUD
Hello Paul,
Quoted 4 lines · Paul Kocialkowski
This is a first attempt at adding support for U-Boot image load from raw partitions. It does not support OS boot as I cannot test it on my current setup.
Quoted 7 lines
Quoted 3 lines
This is going to be useful for the Optimus Black port (please do not consider this as dead code because no board is using it right now, there will be one soon)!
Well... Why don't you just post these two patches a little later, as part of the upcoming series which will add support for the Optimus Black?
Quoted 5 lines
So to me the "dead code" thing is starting to get a lot more ambiguous since with
Kconfigwe'll need need every single possible choice enabled in some defconfig, just some way to turn it on, on a possibly relevant board. In this case, any OMAP3+ board would be a fine place to try this out, IFF it's done as aKconfigchoice.
Not sure I'm understanding you right, but it seems to me we're in sync:
as long as the code is enabled somewhere on some target, it is not dead code. I'm precisely asking that the code here be submitted along with the target that uses it. Or did I miss something?
Quoted 1 line
Tom
Amicalement,
Signature · 1 line
Albert.