Skip to content

arm: reduce .bss section clear time

Lukasz Majewski u-boot 1 version New

Get series with b4
b4 am 20150205105100.435e62fc@amdc2363

Versions newest first

  1. v1 Latest0 of 3 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 3 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH 0/3] arm: reduce .bss section clear time

Hi Simon,

Quoted 43 lines

Hi Lukasz,

Quoted 39 lines · Lukasz Majewski

Dear All,

Quoted 8 lines

And the next is interesting.
odroid_defconfig has more than 80MB for malloc (we need about
64mb for the DFU now, to be able write 32MB file).

This is the CONFIG_SYS_MALLOC_LEN. And the memory area for malloc is set to 0 in function mem_malloc_init(). So for this config that function sets more than 80MB to zero.

Quoted 5 lines

This is not good, because we shouldn't expect zeroed memory returned by malloc pointer. This is a job for calloc.

Especially if some command expects zeroed memory after malloc, probably after few next calls - it can crash...

I think that the above excerpt is _really_ important and should be discussed.

I've "cut" it from the original post, so it won't get lost between the lines.

It seems really strange, that malloc() area is cleared after relocation. Which means that all "first" malloc'ed buffers get implicitly zeroed.

Przemek is right here that this zeroing shouldn't be performed.

I'm also concerned about potential bugs, which show up (or even worse - won't show up soon) after this change.

Hence, I would like to ask directly the community about the possible solutions.

Please look at: ./common/dlmalloc.c mem_alloc_init() function [1].

On the one hand removing memset() at [1] speeds up booting time and makes malloc() doing what is is supposed to do.

Quoted 8 lines
Quoted 2 lines

On the other hand there might be in space some boards, which rely on this memset and without it some wired things may start to happening.

I think removing it is a good idea. It was one optimisation that I did for boot time in the Chromium tree. If you do it now (and Tom agrees) then there is plenty of time to test for this release cycle. You could go further and add a test CONFIG which fills it with some other non-zero value.

Tom, is such approach acceptable for you?

Quoted 3 lines

Regards,
Simon

Signature · 5 lines
Best regards,

Lukasz Majewski

Samsung R&D Institute Poland (SRPOL) | Linux Platform Group