Skip to content

ARM: dts: sun4i: Enable USB DRC and voltage-scaling on pcDuino1/2

Siarhei Siamashka linux-arm-kernel linux-devicetree 2 versions – New

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v2 Latest3 patches 0 repliesNew
  2. v10 of 3 patches 0 repliesSuperseded

Changes in v2 from the cover letter

- The voltage scaling patch (AXP209 PMU regulators) has been already applied by Maxime, so it is not included in this patch set anymore.
- A new patch with a separate dts for pcDuino2 has been added, as had been requested during the previous review round.
- Instead of removing "usb1_vbus-supply" and "usb2_vbus-supply", they now refer to "reg_vcc5v0" (this had been discussed on IRC).

Patches in v2 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/3ARM: dts: sun4i: Allow to use the PH6 pin for GPIO on pcDuino1/2arch/arm/boot/dts/sun4i-a10-pcduino.dts+2 -101 reply
2/3ARM: sun4i: dt: Add new LinkSprite pcDuino2 boardarch/arm/boot/dts/Makefile arch/arm/boot/dts/sun4i-a10-pcduino2.dts+80 -11 reply
3/3ARM: dts: sun4i: Enable USB DRC on pcDuino1/2arch/arm/boot/dts/sun4i-a10-pcduino.dts+19 -01 reply

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v2 yet.

Read the v2 thread

Cover letter [PATCH v2 0/3] ARM: dts: sun4i: Enable USB DRC and voltage-scaling on pcDuino1/2

Hello,

This is the v2 of the older patches from:

    http://lists.infradead.org/pipermail/linux-arm-kernel/2015-October/374377.html

Changes since v1:
- The voltage scaling patch (AXP209 PMU regulators) has been already applied by Maxime, so it is not included in this patch set anymore.
- A new patch with a separate dts for pcDuino2 has been added, as had been requested during the previous review round.
- Instead of removing "usb1_vbus-supply" and "usb2_vbus-supply", they now refer to "reg_vcc5v0" (this had been discussed on IRC).

Siarhei Siamashka (3):
ARM: dts: sun4i: Allow to use the PH6 pin for GPIO on pcDuino1/2
ARM: sun4i: dt: Add new LinkSprite pcDuino2 board
ARM: dts: sun4i: Enable USB DRC on pcDuino1/2

 arch/arm/boot/dts/Makefile               |  3 +-
 arch/arm/boot/dts/sun4i-a10-pcduino.dts  | 29 ++++++++----
 arch/arm/boot/dts/sun4i-a10-pcduino2.dts | 78 ++++++++++++++++++++++++++++++++
 3 files changed, 100 insertions(+), 10 deletions(-)
 create mode 100644 arch/arm/boot/dts/sun4i-a10-pcduino2.dts
Signature · 1 line
2.4.9