Skip to content

mmc: sunxi: Add runtime PM support

Ondřej Jirman linux-arm-kernel linux-mmc 2 versions – New

Get series with b4
b4 am 20180723161634.j7akxttoothslyhi@core

Versions newest first · linked by author and title

  1. v3 Latest posting 2/20 of 7 patches 0 repliesNew
  2. v3 posting 1/20 of 7 patches 0 repliesSuperseded

Patches in v3 posting 2/2 No applies recorded yet

None of the 7 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v3 yet.

Read the v3 thread

Cover letter [PATCH v3 0/7] mmc: sunxi: Add runtime PM support

Hi Maxime,

Quoted 26 lines · Maxime Ripard

Hi Ondrej,

Quoted 23 lines · Ond?ej Jirman
Quoted 5 lines · Maxime Ripard

Hi,

Since it's introduction, our MMC controller has had its external clocks running all the time.

Quoted 8 lines

While that was working great, the power usage and most importantly the EMI that it generated was pretty bad.

Let's implement some runtime_pm hooks with an autosuspend to shut down the whole block when the MMC is not active.

However, some SDIO devices will not probe properly if we keep shutting down the controller, so the autosuspend is disabled for the SDIO devices.

I've tested your patches on TBS A711 tablet (A83T). I get this in the log:

sunxi-mmc 1c10000.mmc: fatal err update clk timeout

Interestingly, this only happens after the first boot. If I hard power cycle the tablet (removing/reinserting the battery) the first boot after that, there's no timeout, and WiFi chip connected to the mmc controller works.

Quoted 8 lines
Quoted 4 lines

Any other reboot (even power cycling via PMIC), it fails with the above error. Maybe there's some unforeseen interaction of runtime PM with mmc-powerseq used for the wifi chip power seuencing? Do you know what's the above error about? I don't know anything about mmc subsystem.

It's kind of weird. Do you have an oscilloscope available to look at the clock signal (and the reset gpio) and see if there's any difference of behaviour?

No, I don't. I can try some printks on the kernel side if it toggles the WiFi reset/power enable gpios differntly.

It looks like something's different on initialization when booting the kernel. WiFi works fine for extended periods of time after the hard power cycle. But when rebooting, it fails.

Adding to the weirdness factor may be the fact that WiFi is not connected via PMIC, so it gets power almost directly from the battery. So kernel may not be doing the WiFi reset properly on boot (which is fine right after the hard power cycle, but leaves the WiFi in unknown state on subsequent reboots).

Thank you and regards,
o.

Quoted 7 lines

Thanks!
Maxime

Signature · 3 lines
Maxime Ripard, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
https://bootlin.com