Skip to content

RFC init: Add s6 as init system

Vadim Kochan buildroot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest3 patches 0 repliesNew

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/3package/s6-linux-init: Build also for the hostpackage/s6-linux-init/s6-linux-init.mk+28 -10 replies
2/3package/s6-linux-init: Allow to install as init systempackage/s6-linux-init/s6-linux-init.mk system/Config.in+47 -20 replies
3/3package/s6-rc: Allow to integrate s6-rc servicespackage/s6-rc/rc.init package/s6-rc/rc.shutdown package/s6-rc/s6-rc.mk+39 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [Buildroot] [RFC 0/3] init: Add s6 as init system

Add new system init support (BR2_INIT_S6) based on s6 suite. This is very-very basic support which does not have any setup automation logic (but only getty) but it allows to install custom s6-rc services in a bit easier way by the board. All s6-rc services which were copied by rootfs-overlay or post-build will be compiled as s6-rc db into /etc/s6-rc/compiled-initial, which also has /etc/s6-rc/compiled link to easy replace it in runtime.

In case if such kind of change will be merged, then may be it would be good to think about of some packages integration into s6-rc system.

Vadim Kochan (3):
package/s6-linux-init: Build also for the host package/s6-linux-init: Allow to install as init system package/s6-rc: Allow to integrate s6-rc services

 package/s6-linux-init/s6-linux-init.mk | 69 +++++++++++++++++++++++++++++++++-
 package/s6-rc/rc.init                  |  4 ++
 package/s6-rc/rc.shutdown              |  3 ++
 package/s6-rc/s6-rc.mk                 | 32 ++++++++++++++++
 system/Config.in                       |  9 ++++-
 5 files changed, 114 insertions(+), 3 deletions(-)
 create mode 100644 package/s6-rc/rc.init
 create mode 100644 package/s6-rc/rc.shutdown
Signature · 1 line
2.14.1