Skip to content

RFC init: Add s6 as init system

Eric Le Bihan buildroot 1 version New

Get series with b4
b4 am 20190120153151.GA22618@itchy

Versions newest first

  1. v1 RFC Latest0 of 3 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 3 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [Buildroot] [RFC 0/3] init: Add s6 as init system

Hi!

Quoted 24 lines · Vadim Kochan

Add new system init support (BR2_INIT_S6) based on s6 suite. This is very-very basic support which does not have any setup automation logic (but only getty) but it allows to install custom s6-rc services in a bit easier way by the board. All s6-rc services which were copied by rootfs-overlay or post-build will be compiled as s6-rc db into /etc/s6-rc/compiled-initial, which also has /etc/s6-rc/compiled link to easy replace it in runtime.

In case if such kind of change will be merged, then may be it would be good to think about of some packages integration into s6-rc system.

Vadim Kochan (3):
package/s6-linux-init: Build also for the host package/s6-linux-init: Allow to install as init system package/s6-rc: Allow to integrate s6-rc services

 package/s6-linux-init/s6-linux-init.mk | 69 +++++++++++++++++++++++++++++++++-
 package/s6-rc/rc.init                  |  4 ++
 package/s6-rc/rc.shutdown              |  3 ++
 package/s6-rc/s6-rc.mk                 | 32 ++++++++++++++++
 system/Config.in                       |  9 ++++-
 5 files changed, 114 insertions(+), 3 deletions(-)
 create mode 100644 package/s6-rc/rc.init
 create mode 100644 package/s6-rc/rc.shutdown
Quoted 3 lines

--
2.14.1

I worked on a s6-based init system eons ago [1], but without using a host variant of s6-linux-init.

I'll test your patches.

[1] https://github.com/elebihan/br2-ext-skarnet

Regards,

--
ELB