Skip to content

net: dsa: mv88e6xxx: fix IPv6

Russell King - ARM Linux admin netdev 4 versions – New

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v4 Latest0 of 3 patches 0 repliesNew
  2. v30 of 3 patches 0 repliesSuperseded
  3. v20 of 3 patches 1 replySuperseded
Earlier versions · 1
VersionPostedPatchesRepliesStatus
v10 of 3 patches0 repliesSuperseded

Patches in v4 No applies recorded yet

None of the 3 patches the cover letter announces are in this archive.

Reviews trailers per patch

PatchVivien DidelotFlorian Fainelli
SeriesR-b R-b R-b R-b R-b R-b

Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.

Read the v4 thread

Cover letter [PATCH net-next v4 0/3] net: dsa: mv88e6xxx: fix IPv6

We have had some emails in private over this issue, this is my current patch set rebased on top of net-next which provides working IPv6 (and probably other protocols as well) over mv88e6xxx DSA switches.

The problem comes down to mv88e6xxx defaulting to not flood unknown unicast and multicast datagrams, as they would be by dumb switches, and as the Linux bridge code does by default.

There is also the issue of IPv6 over a vlan that is transparent to the bridge; the multicast querier will not reach inside the vlan, and so the switch can not learn about multicast routing within the vlan.

These flood settings can be disabled via the Linux bridge code if it's desired to make the switch behave more like a managed switch, eg, by enabling the multicast querier. However, the multicast querier defaults to being disabled which effectively means that by default, mv88e6xxx switches block all multicast traffic. This is at odds with the Linux bridge documentation, and the defaults that the Linux bridge code adopts.

So, this patch set adds DSA support for Linux bridge flags, adds mv88e6xxx support for the unicast and multicast flooding flags, and lastly enables flooding of these frames by default to match the Linux bridge defaults.

 drivers/net/dsa/mv88e6xxx/chip.c | 17 +++++++++++++++++
 include/net/dsa.h                |  2 ++
 net/dsa/dsa_priv.h               |  2 ++
 net/dsa/port.c                   | 33 ++++++++++++++++++++++++++++++---
 net/dsa/slave.c                  |  6 ++++++
 5 files changed, 57 insertions(+), 3 deletions(-)

v2: fix a couple of compile errors in patch 2 and patch 3 (oops).
v3: change interface between core DSA and drivers
v4: fix comments from v3

Signature · 3 lines
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 12.1Mbps down 622kbps up
According to speedtest.net: 11.9Mbps down 500kbps up