Skip to content

net: dsa: mv88e6xxx: fix IPv6

Florian Fainelli netdev 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v5 Latest3 patches 0 repliesNew

Patches in v5 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/3net: dsa: add support for bridge flagsinclude/net/dsa.h net/dsa/dsa_priv.h net/dsa/port.c +1 more+30 -00 replies
2/3net: dsa: mv88e6xxx: add support for bridge flagsdrivers/net/dsa/mv88e6xxx/chip.c+17 -00 replies
3/3net: dsa: enable flooding for bridge portsnet/dsa/port.c+13 -30 replies

Reviews trailers per patch

All 3 patches have a Reviewed-by or Acked-by.

PatchVivien DidelotFlorian Fainelli
1/3R-b
2/3R-b R-b
3/3R-b R-b

Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.

Read the v5 thread

Cover letter [PATCH net-next v5 0/3] net: dsa: mv88e6xxx: fix IPv6

We have had some emails in private over this issue, this is my current patch set rebased on top of net-next which provides working IPv6 (and probably other protocols as well) over mv88e6xxx DSA switches.

The problem comes down to mv88e6xxx defaulting to not flood unknown unicast and multicast datagrams, as they would be by dumb switches, and as the Linux bridge code does by default.

There is also the issue of IPv6 over a vlan that is transparent to the bridge; the multicast querier will not reach inside the vlan, and so the switch can not learn about multicast routing within the vlan.

These flood settings can be disabled via the Linux bridge code if it's desired to make the switch behave more like a managed switch, eg, by enabling the multicast querier. However, the multicast querier defaults to being disabled which effectively means that by default, mv88e6xxx switches block all multicast traffic. This is at odds with the Linux bridge documentation, and the defaults that the Linux bridge code adopts.

So, this patch set adds DSA support for Linux bridge flags, adds mv88e6xxx support for the unicast and multicast flooding flags, and lastly enables flooding of these frames by default to match the Linux bridge defaults.

Russell King (3):
net: dsa: add support for bridge flags
net: dsa: mv88e6xxx: add support for bridge flags
net: dsa: enable flooding for bridge ports

 drivers/net/dsa/mv88e6xxx/chip.c | 17 ++++++++++++++++
 include/net/dsa.h                |  2 ++
 net/dsa/dsa_priv.h               |  2 ++
 net/dsa/port.c                   | 33 +++++++++++++++++++++++++++++---
 net/dsa/slave.c                  |  9 +++++++++
 5 files changed, 60 insertions(+), 3 deletions(-)

v2: fix a couple of compile errors in patch 2 and patch 3 (oops).
v3: change interface between core DSA and drivers
v4: fix comments from v3
v5: fix build failure in patch #1

Signature · 1 line
2.17.1