arm: at91: Makefile: Compile lowlevel_init only when really necessary
Stefan Roese u-boot 3 versions – New
Get series with b4
Patches in v3 No applies recorded yet
Reviews trailers per patch
16 of 20 patches have a Reviewed-by or Acked-by.
| Patch | Heiko Schocher |
| 1/13arm: at91: Makefile: Compile lowlevel_init only when really necessary | R-b T-b |
| 2/13arm: at91: spl_at91.c: Call spl_early_init() if OF_CONTROL is enabled | R-b T-b |
| 3/13serial: atmel_usart: Use fixed clock value in SPL version with DM_SERIAL | R-b T-b |
| 3/13serial: atmel_usart: Use fixed clock value in SPL version with DM_SERIAL | R-b T-b |
| 4/13watchdog: Handle SPL build with watchdog disabled | R-b T-b |
| 5/13watchdog: at91sam9_wdt: Fix WDT setup in at91_wdt_start() | R-b T-b |
| 6/13arm: at91: Remove CONFIG_AT91_HW_WDT_TIMEOUT | |
| 7/13arm: at91: Enable watchdog support | |
| 7/13arm: at91: Enable watchdog support | |
| 7/13arm: at91: Enable watchdog support | |
| 8/13arm: at91: arm926ejs/u-boot-spl.lds: Add _image_binary_end to SPL lds | R-b |
| 9/13Makefile.spl: Move generated AT91SAM NAND image boot.bin to spl directory | R-b T-b |
| 10/13Makefile: Add Kconfig option CONFIG_SPL_IMAGE to select the SPL binary | R-b T-b |
| 10/13Makefile: Add Kconfig option CONFIG_SPL_IMAGE to select the SPL binary | R-b T-b |
| 10/13Makefile: Add Kconfig option CONFIG_SPL_IMAGE to select the SPL binary | R-b T-b |
| 10/13Makefile: Add Kconfig option CONFIG_SPL_IMAGE to select the SPL binary | R-b T-b |
| 10/13Makefile: Add Kconfig option CONFIG_SPL_IMAGE to select the SPL binary | R-b T-b |
| 11/13arm: at91: siemens: Add support to generate combined SPL+U-Boot image | R-b T-b |
| 12/13arm: at91: at91sam9x5.dtsi: Add watchdog handle | R-b |
| 13/13arm: at91: Add gardena-gateway-at91sam support | R-b |
Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.
Read the v3 thread →