gpio: lpc32xx: enable interrupts for port 3
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest3 patches 3 repliesIn review
Patches in v1 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/3 | dt-bindings: gpio: lpc32xx: document interrupt bindingsDocumentation/ | +4 | 1 reply | |
| 2/3 | gpio: lpc32xx: enable interrupt lookup for port 3drivers/ | +5 | 2 replies | |
| 3/3 | ARM: dts: lpc32xx: add GPIO interruptsarch/ | +25 | 1 reply |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [PATCH 0/3] gpio: lpc32xx: enable interrupts for port 3
Hi,
This series enables interrupt support for GPIOs on port 3. Those are the GPIOs that are connected directl to an interrupt controller (sic1 or sic2). This was tested on a custom LPC3250 design.
The binding includes support for interrupts on port 0 and port 1 but this requires the registration of a proper irqchip and I don't have any way to test it.
Patch 1 and 2 should probably go through the gpio tree while patch 3 should go through arm-soc. They are quite independant and this shoud cause no issue.
Alexandre Belloni (3):
dt-bindings: gpio: lpc32xx: document interrupt bindings
gpio: lpc32xx: enable interrupt lookup for port 3
ARM: dts: lpc32xx: add GPIO interrupts
.../devicetree/bindings/gpio/gpio_lpc32xx.txt | 4 +++ arch/arm/boot/dts/lpc32xx.dtsi | 25 +++++++++++++++++++ drivers/gpio/gpio-lpc32xx.c | 14 ++++------- 3 files changed, 34 insertions(+), 9 deletions(-)
Signature · 1 line
2.20.1