Skip to content

i.MX8QM ROM 7720 a1 board won't boot

Oliver Graute u-boot 1 version New

Get series with b4
b4 am 20190819094226.GB29740@optiplex

Versions newest first

  1. v1 Latest0 of 1 patch 0 repliesNew

Patches in v1 No applies recorded yet

The patch the cover letter announces is not in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH 0/1] i.MX8QM ROM 7720 a1 board won't boot
Quoted 19 lines · Oliver Graute

I'am currently working on the following patch to get the imx8qm-rom7720-a1 board working with recent u-boot v2019.07. Unfortunaly I get no output on my serial line.

I'am not sure if something in my patch is just missing or if my composition of "SCFW + ATF + uboot" which is necessary for this imx8qm board, is not working the right way.

Perhaps somebody can guide me in the right direction to debug this further.

Currently I'am applying the patch and building u-boot this way:

$ export ATF_LOAD_ADDR=0x80000000
$ export BL33_LOAD_ADDR=0x80020000
$ make imx8qm_rom7720_a1_4G_defconfig
$ make flash.bin
$ dd if=u-boot.itb of=flash.bin bs=512 seek=854
$ sudo dd if=flash.bin of=/dev/sd[x] bs=1k seek=32 conv=fsync
Quoted 2 lines

Then I put the SD card into the board and power it on. But no output ony my serial line.

ok I got this working by using the u-boot.bin

$ make u-boot.bin

and put it into the imx-mkimage repo from here:

https://source.codeaurora.org/external/imx/imx-mkimage

to create the full bootstream with scfw + atf + u-boot.

I thought that I could create the full bootsteam directly in u-boot repo with:

Quoted 1 line
$ make flash.bin

as seen for other imx8 boards. Perhaps that is possible too but I don't got it working that way.

U-Boot 2019.07-00001-g5854ff8d0e (Aug 19 2019 - 11:12:49 +0200)

CPU: NXP i.MX8QM RevB A53 at 1200 MHz

Model: Advantech iMX8QM Qseven series
Board: ROM-7720-A1 4GB
Build: SCFW 65afe5f6
Boot:  SD2
DRAM:  3.9 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 2

Loading Environment from MMC... *** Warning - bad CRC, using default environment

In:    serial at 5a060000
Out:   serial at 5a060000
Err:   serial at 5a060000

Net:
Error: ethernet at 5b040000 address not set.
eth-1: ethernet at 5b040000
Error: ethernet at 5b040000 address not set.
Can't find FEC0 clk rate: -22
Could not get PHY for FEC1: addr 1
, eth-1: ethernet at 5b050000
Hit any key to stop autoboot: 0

Best regards,

Oliver