Skip to content

This series adds ethernet support for RPi4.

[email protected] linux-arm-kernel linux-devicetree lkml netdev 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest3 patches 10 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/3dt-bindings: net: bcmgenet add property for max DMA burst sizeDocumentation/devicetree/bindings/net/brcm,bcmgenet.txt+2 -01 reply
2/3net: bcmgenet: use optional max DMA burst size propertydrivers/net/ethernet/broadcom/genet/bcmgenet.c drivers/net/ethernet/broadcom/genet/bcmgenet.h+12 -21 reply
3/3ARM: dts: bcm2711: Enable GENET support for the RPi4arch/arm/boot/dts/bcm2711-rpi-4-b.dts arch/arm/boot/dts/bcm2711.dtsi+40 -08 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH v1 0/3] This series adds ethernet support for RPi4.

From: Matthias Brugger <[email protected]>

Raspberry Pi 4 uses the broadcom genet chip in version five. This chip has a dma controller integrated. Up to now the maximal burst size was hard-coded to 0x10. But it turns out that Raspberry Pi 4 does only work with the smaller maximal burst size of 0x8.

This series adds a new optional property to the driver, dma-burst-sz. The very same property is already used by another drivers in the kernel.

Matthias Brugger (3):
dt-bindings: net: bcmgenet add property for max DMA burst size
net: bcmgenet: use optional max DMA burst size property
ARM: dts: bcm2711: Enable GENET support for the RPi4

 .../devicetree/bindings/net/brcm,bcmgenet.txt |  2 ++
 arch/arm/boot/dts/bcm2711-rpi-4-b.dts         | 22 +++++++++++++++++++
 arch/arm/boot/dts/bcm2711.dtsi                | 18 +++++++++++++++
 .../net/ethernet/broadcom/genet/bcmgenet.c    | 13 +++++++++--
 .../net/ethernet/broadcom/genet/bcmgenet.h    |  1 +
 5 files changed, 54 insertions(+), 2 deletions(-)
Signature · 1 line
2.23.0