Skip to content

Better voltage controller configuration for droid4

Tony Lindgren linux-arm-kernel linux-omap 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest2 patches 0 repliesNew

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/2ARM: OMAP2+: Configure voltage controller for retentionarch/arm/mach-omap2/vc.c arch/arm/mach-omap2/vc.h+30 -40 replies
2/2ARM: OMAP2+: Configure voltage controller for cpcap to low-speedarch/arm/mach-omap2/pmic-cpcap.c arch/arm/mach-omap2/vc.c+14 -60 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/2] Better voltage controller configuration for droid4

Hi,

Here are two more patches to change droid4 to use low-speed configuration like the Motorola Mapphone Android Linux kernel does.

This gains us a power saving of 7mW bringing the whole device power consumption in retention idle mode to about 32mW between wakeups with screen blanked, modem off, usb and phy modules unloaded and wlan connected. That's about the same number as I measured Android do in flight mode suspended.

With the pending modem patches with modem online, I'm now seeing average power consumption of about 60 - 70mW for the whole device as measured once a minute from /sys/class/power_supply/battery/power_avg.

The patches are against v5.4-rc1 on top of the related patches:

[PATCH 0/8] Improve PM for omap4 devices

Regards,

Tony

Tony Lindgren (2):
ARM: OMAP2+: Configure voltage controller for retention
ARM: OMAP2+: Configure voltage controller for cpcap to low-speed

 arch/arm/mach-omap2/pmic-cpcap.c | 18 ++++++++++++-----
 arch/arm/mach-omap2/vc.c         | 34 ++++++++++++++++++++++++++++----
 arch/arm/mach-omap2/vc.h         |  2 +-
 3 files changed, 44 insertions(+), 10 deletions(-)
Signature · 1 line
2.23.0