mtd: spi-nor-core: add xSPI Octal DTR support
Get series with b4
b4 am [email protected]Versions newest first · linked by author and title
- v6 Latest posting 2/21 of 21 patches 0 repliesNew
- v6 posting 1/20 of 21 patches 0 repliesSuperseded
- v30 of 17 patches 0 repliesSuperseded
Earlier versions · 1
| Version | Posted | Patches | Replies | Status |
|---|---|---|---|---|
| v1 | 3 patches | 0 replies | Superseded |
1 of 21 patches is in this archive. The cover letter announces 21.
Patches in v6 posting 2/2 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 21/21 | mtd: spi-nor-core: Allow using Micron mt35xu512aba in Octal DTR mode | +0 | 0 replies |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v6 yet.
Cover letter [PATCH v6 00/21] mtd: spi-nor-core: add xSPI Octal DTR support
Quoted 28 lines · Jagan Teki
Quoted 27 lines · Vignesh Raghavendra
Hi Jagan,
Quoted 22 lines · Pratyush Yadav
Quoted 9 lines · Pratyush Yadav
Hi,
This series adds support for octal DTR flashes in the spi-nor framework, and then adds hooks for the Cypress Semper flash which is an xSPI compliant Octal DTR flash.
The Cadence QSPI controller driver is also updated to run in Octal DTR mode.
Quoted 6 lines
Tested on TI J721e EVM.
The Travis CI build can be found here [0]. It is from the previous version, but there is no code change between the two versions.
[0] https://travis-ci.org/github/prati0100/uboot/builds/694602802
Jagan,
Do you have any comments for the series? If not, can it please be merged in?
Quoted 6 lines
Quoted 2 lines
Ping, given that merge window is opening shortly.. Could you take a look at this series?
Except for soft reset patches, the rest of them seems okay. Is Linux support the same way w/o CONFIG options?
Yes, patches are mostly similar to what is being discussed on Linux list. Note that soft reset is optional and is required only in case ROM leaves Flash in Octal DDR (or such stateful modes). In such cases, U-Boot cannot read Device ID and do flash specific initialization, therefore its necessary to soft reset the flash to get it back to 1 bit mode/1S-1S-1S mode in order to start flash detection.
Linux can get away with this as bootloader such as U-Boot would take care of handing over flash in default 1 bit/1S-1S-1S mode.
Regards
Vignesh