RFC vDSO support for Hyper-V guest on ARM64
Get series with b4
b4 am [email protected]Versions newest first
- v1 RFC Latest6 patches 7 repliesIn review
Patches in v1 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/6 | arm64: hyperv: Allow hv_get_raw_timer() definition to be overriddenarch/ | +8 | 0 replies | |
| 2/6 | arm64: vdso: Add support for multiple vDSO data pagesarch/ | +26 | 0 replies | |
| 3/6 | arm/arm64: clocksource: Introduce vclock_modearch/ arch/ arch/ +5 more | +22 | 0 replies | |
| 4/6 | arm64: vdso: hyperv: Map tsc page into vDSO if enabledarch/ arch/ | +23 | 0 replies | |
| 5/6 | arm64: hyperv: Enable userspace to read cntvctarch/ | +7 | 0 replies | |
| 6/6 | arm64: hyperv: Enable vDSOarch/ arch/ arch/ | +22 | 2 replies |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [RFC 0/6] vDSO support for Hyper-V guest on ARM64
Hi,
This is the RFC patchset for vDSO support in ARM64 Hyper-V guest. To test it, Michael's ARM64 support patchset:
https://lore.kernel.org/linux-arm-kernel/[email protected]/
is needed.
Similar as x86, Hyper-V on ARM64 use a TSC page for guests to read the virtualized hardware timer, this TSC page is read-only for the guests, so could be used for vDSO data page. And the vDSO (userspace) code could use the same code for timer reading as kernel, since they read the same TSC page.
This patchset therefore extends ARM64's __vsdo_init() to allow multiple data pages and introduces the vclock_mode concept similar to x86 to allow different platforms (bare-metal, Hyper-V, etc.) to switch to different __arch_get_hw_counter() implementations. The rest of this patchset does the necessary setup for Hyper-V guests: mapping tsc page, enabling userspace to read cntvct, etc. to enable vDSO.
This patchset consists of 6 patches:
patch #1 allows hv_get_raw_timer() definition to be overridden for userspace and kernel to share the same hv_read_tsc_page() definition.
patch #2 extends ARM64 to support multiple vDSO data pages.
patch #3 introduces vclock_mode similiar to x86 to allow different __arch_get_hw_counter() implementations for different clocksources.
patch #4 maps Hyper-V TSC page into vDSO data page.
patch #5 allows userspace to read cntvct, so that userspace can efficiently read the clocksource.
patch #6 enables the vDSO for ARM64 Hyper-V guest.
The whole patchset is based on v5.5-rc1 plus Michael's ARM64 support patchset, and I've done a few tests with:
https://github.com/nlynch-mentor/vdsotest
Comments and suggestions are welcome!
Regards,
Boqun