Skip to content

RFC iommu: Per-group default domain type

Lu Baolu linux-iommu linux-pci lkml 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest4 patches 14 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/4driver core: Add iommu_passthrough to struct deviceinclude/linux/device.h+3 -00 replies
2/4PCI: Add "pci=iommu_passthrough=" parameter for iommu passthroughDocumentation/admin-guide/kernel-parameters.txt drivers/pci/pci.c drivers/pci/pci.h +1 more+42 -04 replies
3/4iommu: Preallocate iommu group when probing devicesdrivers/iommu/iommu.c+66 -266 replies
4/4iommu: Determine default domain type before allocating domaindrivers/iommu/iommu.c+32 -30 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [RFC PATCH 0/4] iommu: Per-group default domain type

An IOMMU group represents the smallest set of devices that are considered to be isolated. All devices belonging to an IOMMU group share a default domain for DMA APIs. There are two types of default domain: IOMMU_DOMAIN_DMA and IOMMU_DOMAIN_IDENTITY. The former means IOMMU translation, while the latter means IOMMU by-pass.

Currently, the default domain type for the IOMMU groups is determined globally. All IOMMU groups use a single default domain type. The global default domain type can be adjusted by kernel build configuration or kernel parameters.

More and more users are looking forward to a fine grained default domain type. For example, with the global default domain type set to translation, the OEM verndors or end users might want some trusted and fast-speed devices to bypass IOMMU for performance gains. On the other hand, with global default domain type set to by-pass, some devices with limited system memory addressing capability might want IOMMU translation to remove the bounce buffer overhead.

This series proposes per-group default domain type to meet these demands. It adds a per-device iommu_passthrough attribute. By setting this attribute, end users or device vendors are able to tell the IOMMU subsystem that this device is willing to use a default domain of IOMMU_DOMAIN_IDENTITY. The IOMMU device probe procedure is reformed to pre-allocate groups for all devices on a specific bus before adding the devices into the groups. This enables the IOMMU device probe precedure to determine a per-group default domain type before allocating IOMMU domains and attaching them to devices.

Please help to review it. Your comments and suggestions are appricated.

Best regards,
baolu

Lu Baolu (4):
driver core: Add iommu_passthrough to struct device
PCI: Add "pci=iommu_passthrough=" parameter for iommu passthrough
iommu: Preallocate iommu group when probing devices
iommu: Determine default domain type before allocating domain

 .../admin-guide/kernel-parameters.txt         |   5 +
 drivers/iommu/iommu.c                         | 127 ++++++++++++++----
 drivers/pci/pci.c                             |  34 +++++
 drivers/pci/pci.h                             |   1 +
 drivers/pci/probe.c                           |   2 +
 include/linux/device.h                        |   3 +
 6 files changed, 143 insertions(+), 29 deletions(-)
Signature · 1 line
2.17.1