Skip to content

spl: fix entry_point equal to load_addr

sbabic at denx.de u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v2 Latest21 patches 0 repliesNew

Patches in v2 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/21spl: fix entry_point equal to load_addr+0 -00 replies
2/21armv7m: cache: add mmu_set_region_dcache_behaviour() stub for compatibility+0 -00 replies
3/21clk: imx: pllv3: register PLLV3 GENERIC and USB as 2 different clocks+0 -00 replies
4/21clk: imx: pllv3: set div_mask differently if PLLV3 is GENERIC or USB+0 -00 replies
5/21clk: imx: pllv3: add enable() support+0 -00 replies
6/21clk: imx: pllv3: add disable() support+0 -00 replies
7/21clk: imx: pllv3: add set_rate() support+0 -00 replies
8/21clk: imx: pllv3: add PLLV3_SYS support+0 -00 replies
9/21clk: imx: pllv3: add support for PLLV3_AV type+0 -00 replies
10/21clk: imx: pfd: add set_rate()+0 -00 replies
11/21clk: imx: add i.IMXRT1050 clk driver+0 -00 replies
12/21pinctrl: add i.MXRT driver+0 -00 replies
13/21gpio: mxc_gpio: add support for i.MXRT1050+0 -00 replies
14/21ARM: dts: imxrt1050: add dtsi file+0 -00 replies
15/21serial_lpuart: add clock enable if CONFIG_CLK is defined+0 -00 replies
16/21serial_lpuart: add support for i.MXRT+0 -00 replies
17/21ram: add SDRAM driver for i.MXRT SoCs+0 -00 replies
18/21mmc: fsl_esdhc: make if(CONFIG_IS_ENABLED(CLK)) an #if statement+0 -00 replies
19/21mmc: fsl_esdhc: add compatible for fsl, imxrt-usdhc+0 -00 replies
20/21imx: Add basic support for the NXP IMXRT10xx SoC family+0 -00 replies
21/21imx: imxrt1050-evk: Add support for the NXP i.MXRT1050-EVK+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v2 yet.

Read the v2 thread