Skip to content

Add software flow control support for STM32 UART

[email protected] linux-arm-kernel linux-devicetree linux-serial lkml 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest2 patches 2 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/2dt-bindings: serial: Add binding for software flow control in STM32 UARTDocumentation/devicetree/bindings/serial/st,stm32-uart.yaml+14 -10 replies
2/2tty: serial: Add software flow control support for STM32 USARTdrivers/tty/serial/stm32-usart.c drivers/tty/serial/stm32-usart.h+141 -60 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/2] Add software flow control support for STM32 UART

From: Manivannan Sadhasivam <[email protected]>

Hello,

This patchset adds software flow control support for STM32 UART controller. This is necessary for the upcoming STM32MP1 based board called Stinger96 IoT-Box. On that board, a bluetooth chip is connected to one of the UART controller but the CTS/RTS lines got swapped mistakenly. So in order to workaround that hardware bug and also to support the usecase of using only Tx/Rx pins, this patchset adds software flow control support.

This patchset has been validated w/ Stinger96 IoT-Box connected to Murata WiFi-BT combo chip.

Thanks,
Mani

Manivannan Sadhasivam (2):
dt-bindings: serial: Add binding for software flow control in STM32
UART
tty: serial: Add software flow control support for STM32 USART

 .../bindings/serial/st,stm32-uart.yaml        |  15 +-
 drivers/tty/serial/stm32-usart.c              | 143 +++++++++++++++++-
 drivers/tty/serial/stm32-usart.h              |   4 +
 3 files changed, 155 insertions(+), 7 deletions(-)
Signature · 7 lines
2.17.1


_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel