Skip to content

hyperv: Enable SCONTROL if SYNIC is enabled

Jon Doron qemu-devel 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest1 patch 2 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/1hyperv: Enable SCONTROL if SYNIC is enabledtarget/i386/kvm.c+2 -02 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH v1 0/1] hyperv: Enable SCONTROL if SYNIC is enabled

Based on an analysis of the HyperV firmwares (Gen1 and Gen2) it seems like the SCONTROL is not being set to the ENABLED state as like we have thought.

Also from a test done by Vitaly Kuznetsov, running a nested HyperV it was concluded that the first access to the SCONTROL MSR with a read resulted with the value of 0x1, aka HV_SYNIC_CONTROL_ENABLE.

It's important to note that this diverges from the value states in the HyperV TLFS of 0.

Jon Doron (1):
hyperv: Enable SCONTROL if SYNIC is enabled

 target/i386/kvm.c | 2 ++
 1 file changed, 2 insertions(+)
Signature · 1 line
2.24.1