Skip to content

Add Seville Ethernet switch to T1040RDB

Vladimir Oltean linux-devicetree linuxppc-dev lkml netdev 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest4 patches 1 replyIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/4powerpc: dts: t1040: add bindings for Seville Ethernet switcharch/powerpc/boot/dts/fsl/t1040si-post.dtsi+75 -00 replies
2/4powerpc: dts: t1040: label the 2 MDIO controllersarch/powerpc/boot/dts/fsl/t1040si-post.dtsi+2 -20 replies
3/4powerpc: dts: t1040rdb: put SGMII PHY under &mdio0 labelarch/powerpc/boot/dts/fsl/t1040rdb.dts+6 -61 reply
4/4powerpc: dts: t1040rdb: add ports for Seville Ethernet switcharch/powerpc/boot/dts/fsl/t1040rdb.dts+111 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH devicetree 0/4] Add Seville Ethernet switch to T1040RDB

Seville is a DSA switch that is embedded inside the T1040 SoC, and supported by the mscc_seville DSA driver. The driver has been accepted this release cycle and is currently available in net-next (and therefore, in linux-next).

This series adds this switch to the SoC's dtsi files and to the T1040RDB board file.

Vladimir Oltean (4):
powerpc: dts: t1040: add bindings for Seville Ethernet switch
powerpc: dts: t1040: label the 2 MDIO controllers
powerpc: dts: t1040rdb: put SGMII PHY under &mdio0 label
powerpc: dts: t1040rdb: add ports for Seville Ethernet switch

 arch/powerpc/boot/dts/fsl/t1040rdb.dts      | 123 +++++++++++++++++++-
 arch/powerpc/boot/dts/fsl/t1040si-post.dtsi |  79 ++++++++++++-
 2 files changed, 194 insertions(+), 8 deletions(-)
Signature · 1 line
2.25.1