implement I2C retries for mXT1368
Get series with b4
b4 am [email protected]Versions newest first · linked by author and title
- v3 Latest3 patches 2 repliesIn review
- v23 patches 5 repliesSuperseded
- v13 patches 1 replySuperseded
Changes in v3 from the cover letter
change compatible string to lowercase
Patches in v3 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/3 | dt-bindings: input: atmel: add compatible for mXT1386Documentation/ | +1 | 0 replies | |
| 2/3 | Input: atmel_mxt_ts - implement I2C retries for mXT1368drivers/ | +50 | 0 replies | |
| 3/3 | ARM: tegra: add mXT1386 compatiblearch/ | +1 | 0 replies |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v3 yet.
Cover letter [PATCH v3 0/3] implement I2C retries for mXT1368
According to datasheet, mXT1386 chip has a WAKE line, it is used to wake the chip up from deep sleep mode before communicating with it via the I2C-compatible interface.
if the WAKE line is connected to a GPIO line, the line must be asserted 25 ms before the host attempts to communicate with the mXT1386.
If the WAKE line is connected to the SCL pin, the mXT1386 will send a NACK on the first attempt to address it, the host must then retry 25 ms later.
This patch adds compatible string "atmel,mXT1386" for mXT1386 controller, when I2C transfer on mXT1386 fails, retry the transfer once after a 25 ms sleep.
Jiada Wang (3):
dt-bindings: input: atmel: add compatible for mXT1386
Input: atmel_mxt_ts - implement I2C retries for mXT1368
ARM: tegra: add mXT1386 compatible
---
v3:
change compatible string to lowercase
v2:
add bool retry_i2c_transfers to struct mxt_data, to indicate whether retry is needed when i2c transfer fails
v1: initial version
--- .../bindings/input/atmel,maxtouch.txt | 1 + .../boot/dts/tegra20-acer-a500-picasso.dts | 2 +- drivers/input/touchscreen/atmel_mxt_ts.c | 62 +++++++++++++++---- 3 files changed, 52 insertions(+), 13 deletions(-)
Signature · 1 line
2.17.1