Skip to content

sunxi: use mainline arm-trusted-firmware

Thomas Petazzoni buildroot 1 version New

Get series with b4
b4 am 20210610152205.451e1374@windsurf

Versions newest first

  1. v2 Latest2 of 28 patches 0 repliesNew

2 of 28 patches are in this archive. The cover letter announces 28.

Patches in v2 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/28boot/arm-trusted-firmware: option to disable stack protection+0 -03 replies
1/28boot/arm-trusted-firmware: option to disable stack protection+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v2 yet.

Read the v2 thread

Cover letter [Buildroot] [PATCH v2 00/28] sunxi: use mainline arm-trusted-firmware

Hello Sergey,

Thanks a lot for this work! See below some comments/doubts, though.

Quoted 6 lines · On Wed, 9 Jun 2021 22:59:35 +0300 Sergey Matyukevich <[email protected]>…

Finally, let me re-iterate once again: I have only orangepi-zero-plus2 board at my disposal. So only this board has been tested. For all the other boards only build tests have been completed. ATF provides only basic support for H5/A64 and SCP firmware is disabled, so I do not expect any surprises here. But still, any help with boot tests on other H5/A64 sunxi boards is more than welcome.

Then, I'm not sure of the approach. Indeed, the defconfigs are really meant to be configurations that have been tested on HW. If we start changing them without testing them on HW, their purpose kind of goes away. What is your plan here? Wait for the initial submitters to confirm that the change is OK and working on HW ? It might take a while. Or should we give up on that promise that all defconfigs have been tested on HW ?

Thanks!

Thomas

Signature · 3 lines
Thomas Petazzoni, co-owner and CEO, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com