Skip to content

Enhancements to pcie-tegra194 driver

Vidya Sagar linux-pci linux-phy linux-tegra lkml 3 versions – Applied

Status from this message: Applied, thanks

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v3 Latest21 patches 8 repliesApplied
  2. v29 patches 2 repliesSuperseded
  3. v19 patches 1 replySuperseded

Changes in v3 from the cover letter

* Addressed review comments from Bjorn
* Added new patches to the series

Patches in v3 Applied

#Subject and filesSizeRepliesApplied
1/21PCI: tegra194: Use devm_gpiod_get_optional() to parse "nvidia,refclk-select"drivers/pci/controller/dwc/pcie-tegra194.c+3 -30 replies
2/21PCI: tegra194: Drive CLKREQ signal low explicitlydrivers/pci/controller/dwc/pcie-tegra194.c+2 -00 replies
3/21PCI: tegra194: Fix polling delay for L2 statedrivers/pci/controller/dwc/pcie-tegra194.c+5 -40 replies
4/21PCI: tegra194: Handle errors in BPMP responsedrivers/pci/controller/dwc/pcie-tegra194.c+16 -21 reply
5/21PCI: tegra194: Apply pinctrl settings for both PCIe RP and EPdrivers/pci/controller/dwc/pcie-tegra194.c+13 -60 replies
6/21PCI: tegra194: Refactor LTSSM state polling on surprise downdrivers/pci/controller/dwc/pcie-tegra194.c+32 -230 replies
7/21PCI: tegra194: Disable direct speed change for EPdrivers/pci/controller/dwc/pcie-tegra194.c+4 -00 replies
8/21phy: tegra: p2u: Set ENABLE_L2_EXIT_RATE_CHANGE in calibrationdrivers/phy/tegra/phy-tegra194-p2u.c+14 -03 replies
9/21PCI: tegra194: Calibrate P2U for endpoint modedrivers/pci/controller/dwc/pcie-tegra194.c+3 -00 replies
10/21PCI: tegra194: Free resources during controller deinitializationdrivers/pci/controller/dwc/pcie-tegra194.c+4 -00 replies
11/21PCI: tegra194: Remove IRQF_ONESHOT flag during Endpoint interrupt registrationdrivers/pci/controller/dwc/pcie-tegra194.c+1 -12 replies
12/21PCI: tegra194: Enable DMA interruptdrivers/pci/controller/dwc/pcie-tegra194.c+14 -00 replies
13/21PCI: tegra194: Enable hardware hot reset mode in Endpointdrivers/pci/controller/dwc/pcie-tegra194.c+2 -00 replies
14/21PCI: tegra194: Allow system suspend when the Endpoint link is not updrivers/pci/controller/dwc/pcie-tegra194.c+16 -40 replies
15/21PCI: tegra194: Disable L1.2 capability of Tegra234 EPdrivers/pci/controller/dwc/pcie-tegra194.c+5 -20 replies
16/21PCI: tegra194: Set LTR message request before PCIe link updrivers/pci/controller/dwc/pcie-tegra194.c+5 -50 replies
17/21PCI: tegra194: Reduce AXI slave timeout valuedrivers/pci/controller/dwc/pcie-tegra194.c+24 -01 reply
18/21PCI: tegra194: Don't force the device into the D0 state before L2drivers/pci/controller/dwc/pcie-tegra194.c+0 -410 replies
19/21PCI: tegra194: Free up EP resources during remove()drivers/pci/controller/dwc/pcie-tegra194.c+2 -01 reply
20/21dt-bindings: PCI: tegra194: Add monitor clock supportDocumentation/devicetree/bindings/pci/nvidia,tegra194-pcie-ep.yaml Documentation/devicetree/bindings/pci/nvidia,tegra194-pcie.yaml+10 -20 replies
21/21PCI: tegra194: Add core monitor clock supportdrivers/pci/controller/dwc/pcie-tegra194.c+20 -10 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v3 yet.

Read the v3 thread

Cover letter [PATCH V3 00/21] Enhancements to pcie-tegra194 driver

This patch series contains enhancements to the pcie-tegra194.c driver that works for both Tegra194 and Tegra234 SoCs and for both RootPort and Endpoint modes.

This patch series depends on the following series in the same order

PCI: designware-ep: Fix DBI access before core init
https://patchwork.ozlabs.org/project/linux-pci/list/?series=322681

PCI: endpoint: Rework the EPC to EPF notification
https://patchwork.kernel.org/project/linux-pci/list/?series=683493

Add DeInit support in the PCIe Endpoint framework
https://patchwork.kernel.org/project/linux-pci/list/?series=685157

V3:
* Addressed review comments from Bjorn
* Added new patches to the series

V2:
* Addressed review comments from test bot and Vinod

Vidya Sagar (21):
PCI: tegra194: Use devm_gpiod_get_optional() to parse
"nvidia,refclk-select"
PCI: tegra194: Drive CLKREQ signal low explicitly
PCI: tegra194: Fix polling delay for L2 state
PCI: tegra194: Handle errors in BPMP response
PCI: tegra194: Apply pinctrl settings for both PCIe RP and EP
PCI: tegra194: Refactor LTSSM state polling on surprise down
PCI: tegra194: Disable direct speed change for EP
phy: tegra: p2u: Set ENABLE_L2_EXIT_RATE_CHANGE in calibration
PCI: tegra194: Calibrate P2U for endpoint mode
PCI: tegra194: Free resources during controller deinitialization
PCI: tegra194: Remove IRQF_ONESHOT flag during Endpoint interrupt
registration
PCI: tegra194: Enable DMA interrupt
PCI: tegra194: Enable hardware hot reset mode in Endpoint
PCI: tegra194: Allow system suspend when the Endpoint link is not up
PCI: tegra194: Disable L1.2 capability of Tegra234 EP
PCI: tegra194: Set LTR message request before PCIe link up
PCI: tegra194: Reduce AXI slave timeout value
PCI: tegra194: Don't force the device into the D0 state before L2
PCI: tegra194: Free up EP resources during remove()
dt-bindings: PCI: tegra194: Add monitor clock support
PCI: tegra194: Add core monitor clock support

 .../bindings/pci/nvidia,tegra194-pcie-ep.yaml |   6 +-
 .../bindings/pci/nvidia,tegra194-pcie.yaml    |   6 +-
 drivers/pci/controller/dwc/pcie-tegra194.c    | 261 ++++++++++++------
 drivers/phy/tegra/phy-tegra194-p2u.c          |  14 +
 4 files changed, 194 insertions(+), 93 deletions(-)
Signature · 7 lines
2.17.1


-- 
linux-phy mailing list
[email protected]
https://lists.infradead.org/mailman/listinfo/linux-phy