Skip to content

RFC DSA driver draft for MaxLinear's gsw1xx series switch

Camel Guo linux-devicetree lkml netdev 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest2 patches 18 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/2dt-bindings: net: dsa: add bindings for GSW Series switchesDocumentation/devicetree/bindings/net/dsa/mxl,gsw.yaml Documentation/devicetree/bindings/vendor-prefixes.yaml MAINTAINERS+148 -09 replies
2/2net: dsa: Add driver for Maxlinear GSW1XX switchMAINTAINERS drivers/net/dsa/Kconfig drivers/net/dsa/Makefile +3 more+999 -09 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [RFC net-next 0/2] DSA driver draft for MaxLinear's gsw1xx series switch

Hi netdev,

Recently I had been working on implementing DSA driver for MaxLinear GSW145 switch. Here is my initial draft. Before proceeding futher, I am hoping to get comments and cooperation as early/many as possible.

On my hand, I have an arm64 board with one GSW145 chip being connected via MDIO management interface. According to the public datasheet of GSW145, the chip itself on my board is in self-start (PS_NOWAIT=1b), managed switch (PS_OP_MD=11) mode. On this board, only two slave ethernet ports (port0, port1) of this chip are enabled.

As its datasheet says, this chip supports MDIO, SPI, UART management interfaces in many operation modes (self-start/non-self-start, managed/standalone). Unfortunately it is impossible for me to run this draft on all of these combinations. It will be very helpful if anyone can help to run it on different hardware setups and send the feedback back to me.

I also noticed that lantiq_gswip.c looks similar as gsw145. I have no access to the datasheet of the chip this file supports. Maybe they can be merged together.

Best Regards
Camel Guo

Camel Guo (2):
dt-bindings: net: dsa: add bindings for GSW Series switches
net: dsa: Add driver for Maxlinear GSW1XX switch

 .../devicetree/bindings/net/dsa/mxl,gsw.yaml  | 140 +++
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 MAINTAINERS                                   |   9 +
 drivers/net/dsa/Kconfig                       |  16 +
 drivers/net/dsa/Makefile                      |   2 +
 drivers/net/dsa/gsw1xx.h                      |  27 +
 drivers/net/dsa/gsw1xx_core.c                 | 823 ++++++++++++++++++
 drivers/net/dsa/gsw1xx_mdio.c                 | 128 +++
 8 files changed, 1147 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/dsa/mxl,gsw.yaml
 create mode 100644 drivers/net/dsa/gsw1xx.h
 create mode 100644 drivers/net/dsa/gsw1xx_core.c
 create mode 100644 drivers/net/dsa/gsw1xx_mdio.c

base-commit: 6143eca3578f486e4d58fe6fb5e96a5699c86fbc

Signature · 1 line
2.30.2