Skip to content

dts: xea: Delete not used in u-boot DTS nodes

[email protected] u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest16 patches 0 repliesNew

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/16dts: xea: Delete not used in u-boot DTS nodes+0 -00 replies
2/16dts: xea: Provide missing FEC required properties (mac0 and reg_fec_3v3)+0 -00 replies
3/16defconfig: xea: Change default spi-nor memory bus to 2+0 -00 replies
4/16spl: xea: Provide stub DM driver for imx28 clocks+0 -00 replies
5/16dts: xea: Enable debug UART support in XEA's SPL (DM_SERIAL)+0 -00 replies
6/16dts: xea: Add u-boot specific 'type' property to duart+0 -00 replies
7/16dts: xea: Remove clocks property from debug UART on XEA+0 -00 replies
8/16dts: xea: Disable 'clks' node for xea (imx287)+0 -00 replies
9/16serial: pl01x: Change OF_CONTROL to OF_REAL+0 -00 replies
10/16serial: pl01x: Prepare the driver to support SPL_OF_PLATDATA+0 -00 replies
11/16serial: pl01x: Modify pending callback to test if transmit FIFO is empty+0 -00 replies
12/16arm: mxs: Prevent serial console init when in very early SPL boot code+0 -00 replies
13/16arm: xea: Call spl_early_init() before DM serial console is enabled in SPL+0 -00 replies
14/16arm: Kconfig: Switch XEA (imx287 based) board to use CONFIG_PL01X_SERIAL+0 -00 replies
15/16config: xea: Enable DM_SERIAL for the XEA (imx287 based) board+0 -00 replies
16/16config: xea: Enable DM_SERIAL for the XEA - single binary (SB) u-boot+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread