Skip to content

Put XHCI controllers into D3 at S4/S5

[email protected] linux-usb lkml 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest2 patches 11 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/2xhci: pci: If no ports have wakeup enabled then disable PCI device at S4drivers/usb/host/xhci-pci.c+9 -02 replies
2/2xhci: pci: Put XHCI controllers into D3hot at shutdowndrivers/usb/host/xhci-pci.c+2 -66 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/2] Put XHCI controllers into D3 at S4/S5

From: Mario Limonciello <[email protected]>

When the system is put into S4 or S5 XHCI controllers remain in D0. This causes higher power consumption and may compromise energy certifications. Consequently some systems consume more power in S5 than s0i3.

This affects all PCIe devices, but looking at breakdowns XHCI is the biggest offender for power consumption.

This series checks if any wakeups are needed and puts controllers into D3 if no wakeup necessary.

This series is a spiritual successor to [1] which aimed to do this more generally in PCI. It also accomplishes similar goals as [2], but aims for both S4 and S5.

[1] https://lore.kernel.org/linux-pci/[email protected]/#t
[2] https://lore.kernel.org/linux-pci/[email protected]/T/

Mario Limonciello (2):
xhci: pci: If no ports have wakeup enabled then disable PCI device at

    S4

xhci: pci: Put XHCI controllers into D3hot at shutdown

 drivers/usb/host/xhci-pci.c | 17 +++++++++++------
 1 file changed, 11 insertions(+), 6 deletions(-)
Signature · 1 line
2.43.0