iio: bmi323: have the peripheral consume less power
Get series with b4
b4 am [email protected]Versions newest first · linked by author and title
- v3 Latest1 patch 3 repliesIn review
- v2 posting 2/21 patch 1 replySuperseded
- v2 posting 1/20 of 1 patch 0 repliesSuperseded
Earlier versions · 1
| Version | Posted | Patches | Replies | Status |
|---|---|---|---|---|
| v1 | 1 patch | 1 reply | Superseded |
Changelog from the cover letter
- V2: patch 1:
+ change patch commit message
+ drop removal callbacks and use devm_add_action_or_reset
+ split bmi323_init in two functions
+ separate regs to save and relative value
+ drop unhelpful consts ptr modifiers
+ add a comment to explain why BMI323_FIFO_CTRL_REG is being used in runtime resume
- V3: patch 1:
+ drop a struct array and replace with an array of unsigned int: u8 was too small and it would have resulted in overflow of register addresses
+ use single-line comments where possible
+ drop useless comments
+ remove intermediate variables
+ remove blank lines
Patches in v3 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/1 | iio: bmi323: peripheral in lowest power state on suspenddrivers/ | +153 | 1 reply |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v3 yet.
Cover letter [PATCH v3 0/1] iio: bmi323: have the peripheral consume less power
The bmi323 chip is part of handhelds PCs that are run on battery.
One of said PC is well-known for its short battery life, even in s2idle:
help mitigate that by putting the device in its lowest-consumption state while the peripheral is unused.
Have runtime-pm suspend callback save used configuration registers and runtime-pm resume callback restore saved registers to restore the previous state.
Changelog:
- V2: patch 1:
+ change patch commit message
+ drop removal callbacks and use devm_add_action_or_reset
+ split bmi323_init in two functions
+ separate regs to save and relative value
+ drop unhelpful consts ptr modifiers
+ add a comment to explain why BMI323_FIFO_CTRL_REG is being used in runtime resume
- V3: patch 1:
+ drop a struct array and replace with an array of unsigned int: u8 was too small and it would have resulted in overflow of register addresses
+ use single-line comments where possible
+ drop useless comments
+ remove intermediate variables
+ remove blank lines
Previous patches obsoleted:
https://lore.kernel.org/all/[email protected]
https://lore.kernel.org/all/[email protected]
Denis Benato (1):
iio: bmi323: peripheral in lowest power state on suspend
drivers/iio/imu/bmi323/bmi323_core.c | 155 ++++++++++++++++++++++++++- 1 file changed, 153 insertions(+), 2 deletions(-)
Signature · 1 line
2.46.0