Skip to content

RFC wifi: ath10k: improvement on key removal failure

James Prestwood ath10k linux-wireless 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest1 patch 2 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/1wifi: ath10k: reduce timeout for disabling a keydrivers/net/wireless/ath/ath10k/mac.c+3 -10 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [RFC 0/1] wifi: ath10k: improvement on key removal failure

This is in regard to my earlier question [1]. After some testing with adding an artificial 3 second delay between auth and assoc frames I saw that the device would fail to roam 100% of the time. This further backed up my theory that this firmware failure is causing some timeout on the AP, and resulting it either ignoring the reassociation or rejecting it.

Changing kernel behavior to fix a vendor quirk isn't great, but in this situation since the key removal is non-fatal and it improves general performance when the firmware does time out I thought it was an acceptable compromise. I am also pursuing the vendor to fix this, and allow a greater delay between auth and assoc.

The reason I'm sending this as an RFC is that I have no idea about other hardware, firmwares, etc, that use ath10k. I have only tested on the QCA6174. Maybe different configurations _do_ need 3 seconds to remove a key? Maybe this timeout needs to be a hw_param?

[1] https://lore.kernel.org/linux-wireless/[email protected]/T/#t

James Prestwood (1):
wifi: ath10k: reduce timeout for disabling a key

 drivers/net/wireless/ath/ath10k/mac.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)
Signature · 1 line
2.34.1