Skip to content

crypto: rockchip: Add RK356x/RK3588 cryptographic offloader

Dawid Olesinski linux-arm-kernel linux-crypto linux-devicetree linux-rockchip lkml 3 versions – In review

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v3 Latest4 patches 4 repliesIn review
  2. v24 patches 11 repliesSuperseded
  3. v14 patches 1 replySuperseded

Changes in v3 from the cover letter

Device tree binding (Sebastian Reichel, Heiko Stübner, sashiko-bot):
- Merge the compatibles: rk3588-crypto now falls back to rk3568-crypto (oneOf schema). The driver binds only against rockchip,rk3568-crypto; the rk3588 string is reserved for future quirks.
- Allow up to three reset lines (core/aclk/hclk) instead of a single reset, so a complete node describing the AXI and AHB resets validates.
- Drop "status = disabled" from the crypto nodes in both rk356x-base.dtsi and rk3588-base.dtsi; the block needs no board-specific resources.

Patches in v3 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/4dt-bindings: crypto: rockchip: Add RK356x/RK3588 crypto engine bindingDocumentation/devicetree/bindings/crypto/rockchip,rk3588-crypto.yaml MAINTAINERS+85 -02 replies
2/4crypto: rockchip: Add RK356x/RK3588 cryptographic offloader driverdrivers/crypto/Kconfig drivers/crypto/Makefile drivers/crypto/rockchip/Makefile +4 more+2356 -02 replies
3/4arm64: dts: rockchip: Add crypto node to rk356x-basearch/arm64/boot/dts/rockchip/rk356x-base.dtsi+11 -00 replies
4/4arm64: dts: rockchip: Add crypto node to rk3588-basearch/arm64/boot/dts/rockchip/rk3588-base.dtsi+11 -00 replies

Reviews trailers per patch

None of the 4 patches has a Reviewed-by or Acked-by.

PatchDiederik de Haas
SeriesT-b
1/4T-b
2/4T-b
3/4T-b
4/4T-b

Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.

Read the v3 thread

Cover letter [PATCH v3 0/4] crypto: rockchip: Add RK356x/RK3588 cryptographic offloader

This series adds support for the second-generation (V2) Rockchip cryptographic hardware accelerator found on RK3568 and RK3588 SoCs.

The IP block provides AES (ECB, CBC, XTS) and hash (SHA-1, SHA-256, SHA-384, SHA-512, MD5, SM3) offload via an LLI-based DMA engine.

The series is ordered as required: binding first, then driver, then the two DTS nodes that reference the binding.

A prerequisite patch removing SECURECRU reset definitions from the non-secure CRU driver is sent separately to the clk/reset tree, as it touches a different subsystem. That patch is not a hard dependency for the driver to build or load, but it is needed for correctness on RK3588:
those register offsets map into TrustZone-protected MMIO and must not be accessed directly by Linux.

This work started from unmerged patches by Corentin Labbe <[email protected]> posted at:
https://patchew.org/linux/[email protected]/

The implementation has been substantially reworked. Notable changes from Corentin's original series:
- DMA descriptor race condition and DMA mapping leak on timeout fixed
- Per-device algorithm copy replaces global device list, removing a locking bottleneck and correctly supporting multiple instances
- Runtime PM autosuspend added; clocks and reset gated between requests
- Multi-SG hash requests routed to software fallback (hardware padding engine requires total message length upfront and cannot maintain state across LLI boundaries)
- Hardware interrupt enable register write corrected to use the HIWORD_UPDATE mask that the hardware requires
- Software fallback for all registered algorithms; statesize promotion for export/import compatibility with ARM Crypto Extensions drivers
- SCMI reset and clock references in DTS corrected for RK3588

Quartz64-B (RK3566), NanoPi R5S (RK3568), NanoPC-T6 LTS (RK3588)

Tested on Orange Pi 5 Pro (RK3588S) and Banana Pi R2 Pro (RK3568).

All ten algorithm selftests pass. AES-CBC throughput measured at ~100 MiB/s with cryptsetup. PM autosuspend/resume verified over 1000 consecutive hash requests with no errors. 20 modprobe/rmmod cycles produce no DMA coherent memory leaks.

Patch series for the crypto subsystem:
[1/4] dt-bindings: crypto: rockchip: Add RK356x/RK3588 crypto engine binding
[2/4] crypto: rockchip: Add RK356x/RK3588 cryptographic offloader driver [3/4] arm64: dts: rockchip: Add crypto node to rk356x-base [4/4] arm64: dts: rockchip: Add crypto node to rk3588-base

Separate patch for clk/reset tree:
clk: rockchip: rk3588: Remove SECURECRU reset definitions

Changes in v3:
Device tree binding (Sebastian Reichel, Heiko Stübner, sashiko-bot):
- Merge the compatibles: rk3588-crypto now falls back to rk3568-crypto (oneOf schema). The driver binds only against rockchip,rk3568-crypto; the rk3588 string is reserved for future quirks.
- Allow up to three reset lines (core/aclk/hclk) instead of a single reset, so a complete node describing the AXI and AHB resets validates.
- Drop "status = disabled" from the crypto nodes in both rk356x-base.dtsi and rk3588-base.dtsi; the block needs no board-specific resources.

Driver (sashiko-bot):
- Add SYSTEM_SLEEP_PM_OPS (pm_runtime_force_suspend / pm_runtime_force_resume) so the hardware is suspended correctly across system sleep even inside the autosuspend window.
- Guard the interrupt handler with pm_runtime_get_if_active() and balance pm_runtime_put() on all return paths, preventing register access to unclocked hardware during the teardown window.
- Allocate the per-device algorithm array with kmemdup() instead of devm_kmemdup() and free it explicitly in remove() after the engine is drained and algorithms are unregistered, so the templates outlive any in-flight teardown.
- Drop the explicit crypto_engine_stop() in remove(); rely on crypto_engine_exit() to stop and synchronously drain the kworker.
- On skcipher DMA timeout, assert reset and synchronize_irq() before unmapping the scatterlists, so delayed hardware cannot write to unmapped memory.
- Add CRYPTO_ALG_TYPE_AHASH support to rk2_crypto_debugfs_stats_show() to print request and fallback counters for hash algorithms.

Driver - cleanup (Diederik de Haas):
- Remove the redundant is_xts template field; test rk2_mode == RK2_CRYPTO_AES_XTS directly.

Driver — correctness and robustness (review round 2):
- Use explicit 32-bit DMA address handling: wrap sg_dma_address() and the LLI base in lower_32_bits() for both the skcipher and hash descriptor programming, making the hardware's 32-bit limitation explicit and silencing sparse on 64-bit builds.
- Fix AES-XTS IV handling: req->iv is the XTS tweak, not a CBC-style chaining IV, so it must not be overwritten with ciphertext. Gate the backup_iv save/restore on a single update_iv flag that excludes XTS, leaving the tweak untouched across chained requests.
- Zero ctx->key (memzero_explicit) and reset keylen when the fallback setkey fails, for both rk2_aes_setkey() and rk2_aes_xts_setkey().
- Harden the IRQ/PM suspend path: mask and clear DMA interrupts in rk2_crypto_pm_suspend() and re-clear/re-enable them in rk2_crypto_pm_resume(), so a pending level-triggered interrupt in the suspend window cannot storm.
- Use crypto_skcipher_set_reqsize() / crypto_ahash_set_reqsize() instead of assigning tfm->reqsize directly.
- Align DMA interrupt bit names in rk2_crypto.h (bits 1–6) with the TRM v1.0 specification.
- Update rk2_crypto_irq_handle() inline comment to reference DST_ITEM_DONE and SRC_ITEM_DONE.

Driver — cleanup:
- Simplify the hash path to a single scatterlist element (multi-SG hash already falls back), removing the now-dead LLI loop.
- Name the AES-192 capability bit (RK2_AES_VER_SUPP_192) and comment it, instead of a bare BIT(17) in the debug info dump.

v2: https://lore.kernel.org/r/[email protected]

Changes in v2:
- dt-bindings: wrap example in a bus node with #address/#size-cells = 2 and add the SCMI clock/reset dt-binding includes so dt_binding_check passes (Rob Herring / Krzysztof Kozlowski review).
- crypto: fix Kconfig to select CRYPTO_SM3 instead of the non-existent CRYPTO_SM3_GENERIC.
- crypto: drop IRQF_SHARED (the line is dedicated) and request the IRQ only after clocks are enabled and the completion is initialised; reorder probe accordingly.
- crypto: set a 32-bit DMA mask before allocating the descriptor table.
- crypto: suspend the device explicitly on removal before disabling runtime PM to avoid leaking clocks.
- crypto: call synchronize_irq() on the DMA timeout paths to close a race with delayed interrupts.
- crypto: convert fallback statistics to atomic_long_t.
- crypto: use cpu_to_le32() for all LLI descriptor fields (big-endian correctness).
- crypto: read key/IV with get_unaligned_be32() to fix an alignment fault and a big-endian double-swap.
- crypto: fix the CBC/XTS IV backup offset to use the processed length instead of the scatterlist capacity.
- arm64: dts: rk356x: move the crypto node into unit-address order.

v1: https://lore.kernel.org/r/[email protected]/

Build/rebase fixes (not from review):
- crypto: use sizeof(struct sm3_ctx) for the SM3 statesize, as struct sm3_state was removed by the lib/crypto SM3 conversion.
- crypto: add the missing SHA-224 zero-message case.

Dawid Olesinski (4):
dt-bindings: crypto: rockchip: Add RK356x/RK3588 crypto engine binding
crypto: rockchip: Add RK356x/RK3588 cryptographic offloader driver
arm64: dts: rockchip: Add crypto node to rk356x-base
arm64: dts: rockchip: Add crypto node to rk3588-base

 .../crypto/rockchip,rk3588-crypto.yaml        |  83 ++
 MAINTAINERS                                   |   2 +
 arch/arm64/boot/dts/rockchip/rk356x-base.dtsi |  11 +
 arch/arm64/boot/dts/rockchip/rk3588-base.dtsi |  11 +
 drivers/crypto/Kconfig                        |  32 +
 drivers/crypto/Makefile                       |   1 +
 drivers/crypto/rockchip/Makefile              |   5 +
 drivers/crypto/rockchip/rk2_crypto.c          | 783 ++++++++++++++++++
 drivers/crypto/rockchip/rk2_crypto.h          | 254 ++++++
 drivers/crypto/rockchip/rk2_crypto_ahash.c    | 541 ++++++++++++
 drivers/crypto/rockchip/rk2_crypto_skcipher.c | 740 +++++++++++++++++
 11 files changed, 2463 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/crypto/rockchip,rk3588-crypto.yaml
 create mode 100644 drivers/crypto/rockchip/rk2_crypto.c
 create mode 100644 drivers/crypto/rockchip/rk2_crypto.h
 create mode 100644 drivers/crypto/rockchip/rk2_crypto_ahash.c
 create mode 100644 drivers/crypto/rockchip/rk2_crypto_skcipher.c
Signature · 1 line
2.47.3