Skip to content

mfd: lm8502: add core MFD driver for TI LM8502

Herman van Hazendonk lkml 2 versions In review

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v2 Latest1 patch 1 replyIn review
  2. v11 patch 0 repliesSuperseded

Changes in v2 from the cover letter

- Resend with cover letter; no code changes

Patches in v2 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/1mfd: lm8502: add core MFD driver for TI LM8502MAINTAINERS drivers/mfd/Kconfig drivers/mfd/Makefile +2 more+669 -01 reply

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v2 yet.

Read the v2 thread

Cover letter [PATCH v2 0/1] mfd: lm8502: add core MFD driver for TI LM8502

Apologies for the noise — v1 (Message-ID:
<[email protected]>) was sent as a bare [PATCH] without a cover letter. This v2 resends with the correct format. No code changes relative to v1.

---

The TI LM8502 is an I2C-attached combo device combining ten constant- current LED outputs (D1..D10) with an internal H-bridge for driving a vibrator motor. Pin D10 is shared between the tenth LED channel and the haptic output.

This patch adds the MFD core driver:

- i2c probe with optional vcc regulator (High Power Mode handshake for RPM-managed LDOs carrying "regulator-allow-set-load") and optional chip-enable GPIO
- Software reset and post-reset configuration sequence
- Chip readiness verification via an LP55xx-style write-CHIP_EN- then-readback loop (250 ms bound); children only probe once the chip is known to be ACKing the bus
- Devres-ordered teardown: lm8502_power_off() registered via devm_add_action_or_reset() *before* devm_mfd_add_devices() so devres LIFO unwinds children first (their .remove callbacks issue final regmap writes against a still-powered chip), then powers off the rail
- MAINTAINERS entry covering all four driver files

Two children are spawned:

ti,lm8502-leds - LED-class outputs D1..D10
ti,lm8502-haptic - EV_FF / FF_RUMBLE input device

The corresponding child drivers land in subsequent patches.

The DT binding for this device was submitted separately:
Subject: [PATCH] dt-bindings: mfd: add ti,lm8502 combo LED + haptic controller

Changes since v1:
- Resend with cover letter; no code changes

Herman van Hazendonk (1):
mfd: lm8502: add core MFD driver for TI LM8502

 MAINTAINERS                |   9 +
 drivers/mfd/Kconfig        |  18 ++
 drivers/mfd/Makefile       |   1 +
 drivers/mfd/lm8502.c       | 511 +++++++++++++++++++++++++++++++++++++
 include/linux/mfd/lm8502.h | 130 ++++++++++
 5 files changed, 669 insertions(+)
 create mode 100644 drivers/mfd/lm8502.c
 create mode 100644 include/linux/mfd/lm8502.h

base-commit: 944125b4c454b58d2fe6e35f1087a932b2050dff --
2.43.0