phy: nuvoton: Add MA35D1 USB2 OTG PHY driver
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest2 patches 4 repliesIn review
Patches in v1 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/2 | dt-bindings: phy: nuvoton: Add MA35D1 USB2 OTG PHY bindingDocumentation/ | +79 | 2 replies | |
| 2/2 | phy: nuvoton: Add MA35D1 USB2 OTG PHY driverdrivers/ drivers/ drivers/ | +280 | 2 replies |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [PATCH 0/2] phy: nuvoton: Add MA35D1 USB2 OTG PHY driver
The Nuvoton MA35D1 SoC has two USB 2.0 ports:
USB0 is an OTG-capable port. Its physical signals are routed by a hardware mux to either a DWC2 gadget controller or the EHCI0/OHCI0 host controllers, depending on the USB ID pin state. The DWC2 IP is device-only in hardware, so all host-mode operation on USB0 is handled by EHCI0/OHCI0.
USB1 is a dedicated host-only port served by EHCI1/OHCI1.
About this driver:
- Runs the PHY Power-On Reset sequence, with a guard that skips re-initialization if the PHY is already operational.
- Supports optional resistor calibration trim (nuvoton,rcalcode) and over-current detect polarity configuration (nuvoton,oc-active-high).
- For PHY0 (USB0) only: registers a USB role switch that reads the hardware ID pin state from PWRONOTP[16] on every query.
Joey Lu (2):
dt-bindings: phy: nuvoton: Add MA35D1 USB2 OTG PHY binding
phy: nuvoton: Add MA35D1 USB2 OTG PHY driver
.../phy/nuvoton,ma35d1-usb2-phy-otg.yaml | 79 ++++++ drivers/phy/nuvoton/Kconfig | 15 + drivers/phy/nuvoton/Makefile | 1 + drivers/phy/nuvoton/phy-ma35d1-otg.c | 264 ++++++++++++++++++ 4 files changed, 359 insertions(+) create mode 100644 Documentation/devicetree/bindings/phy/nuvoton,ma35d1-usb2-phy-otg.yaml create mode 100644 drivers/phy/nuvoton/phy-ma35d1-otg.c
Signature · 1 line
2.43.0