wifi: mt76: mt792x: harden USB reset and disconnect paths
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest6 patches 0 repliesNew
Patches in v1 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/6 | wifi: mt76: mt7925: stop init retries on hung busdrivers/ | +8 | 0 replies | |
| 2/6 | wifi: mt76: mt7925: skip reset work on hung busdrivers/ drivers/ | +13 | 0 replies | |
| 3/6 | wifi: mt76: mt792x: stop USB register access after bus hangdrivers/ drivers/ drivers/ | +82 | 0 replies | |
| 4/6 | wifi: mt76: mt792x: drain USB UDMA before WFSYS resetdrivers/ | +20 | 0 replies | |
| 5/6 | wifi: mt76: mt792x: enable USB UDMA TX timeoutdrivers/ | +5 | 0 replies | |
| 6/6 | wifi: mt76: mt792x: quiesce USB paths on disconnectdrivers/ | +17 | 0 replies |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [PATCH 0/6] wifi: mt76: mt792x: harden USB reset and disconnect paths
This series hardens mt792x USB reset and disconnect handling.
When the USB control path starts timing out, later register accesses can keep entering the same dead transport. Each timed-out vendor request may block for seconds, so reset or disconnect can be delayed by repeated accesses that can no longer make progress.
Avoid this by failing fast once the USB bus is known to be hung, stopping reset/init retry paths that cannot recover the device, draining UDMA before WFSYS reset, and quiescing USB activity before unregistering the device.
This series does the following:
- stop mt7925 init retries once the USB bus is hung
- skip mt7925 reset work once the USB bus is hung
- switch later USB register accesses to no-op bus ops after bus hang
- drain USB UDMA before WFSYS reset
- enable the USB UDMA TX timeout limit
- stop pending USB work and TX paths before unregistering the device
The series is based on wireless-next commit:
21352612198c ("b43: add RF power offset for N-PHY r8 + radio 2057 r8")
It also cherry-picks the following patch from patchwork as a dependency:
wifi: mt76: mt76u: use a threaded NAPI for the RX path
Sean Wang (6):
wifi: mt76: mt7925: stop init retries on hung bus
wifi: mt76: mt7925: skip reset work on hung bus
wifi: mt76: mt792x: stop USB register access after bus hang
wifi: mt76: mt792x: drain USB UDMA before WFSYS reset
wifi: mt76: mt792x: enable USB UDMA TX timeout
wifi: mt76: mt792x: quiesce USB paths on disconnect
drivers/net/wireless/mediatek/mt76/mt76.h | 1 + .../net/wireless/mediatek/mt76/mt7925/init.c | 8 ++ .../net/wireless/mediatek/mt76/mt7925/mac.c | 6 + .../net/wireless/mediatek/mt76/mt7925/usb.c | 7 + .../net/wireless/mediatek/mt76/mt792x_usb.c | 124 ++++++++++++++++-- drivers/net/wireless/mediatek/mt76/usb.c | 11 ++ 6 files changed, 145 insertions(+), 12 deletions(-)
Signature · 1 line
2.43.0