Add no-hpd property to the cadence bridge
Get series with b4
b4 am [email protected]Versions newest first · linked by author and title
- v7 Latest2 patches 2 repliesIn review
- v62 patches 3 repliesSuperseded
- v5 posting 2/22 patches 5 repliesSuperseded
Earlier versions · 2
| Version | Posted | Patches | Replies | Status |
|---|---|---|---|---|
| v5 posting 1/2 | 2 patches | 3 replies | Superseded | |
| v4 | 2 patches | 2 replies | Superseded |
Changes in v7 from the cover letter
- Reverted back to dev_dbg instead of dev_err for the normal hpd case.
- Picked up Acked-by from Krzysztof Kozlowski from v6 on the bindings patch.
Patches in v7 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/2 | dt-bindings: display: bridge: cdns,mhdp8546: Add no-hpd property to the cadence bridgeDocumentation/ | +11 | 0 replies | |
| 2/2 | drm: bridge: cdns-mhdp8546: Add no-hpd propertydrivers/ drivers/ | +64 | 0 replies |
Reviews trailers per patch
1 of 2 patches has a Reviewed-by or Acked-by.
| Patch | Krzysztof Kozlowski |
|---|---|
| 1/2 | A-b |
| 2/2 |
Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.
Cover letter [PATCH v7 0/2] Add no-hpd property to the cadence bridge
This series adds 'no-hpd' device tree property support to the Cadence MHDP8546 bridge driver for boards where the HPD line cannot be used for hotplug detection.
On TI J721S2 EVMs, the DP0 HPD resistor is DNI from factory, so the HPD signal is not physically connected to SoC pin AA24 by default. AA24 must still be in DP0_HPD mux mode for the MHDP firmware to operate.
When 'no-hpd' is set, DRM_BRIDGE_OP_HPD is omitted and the framework falls back to polling .detect() every ~10 seconds. Presence is detected by reading DP_DPCD_REV (0x000) over AUX, with an early exit when the monitor is stably connected to avoid re-programming the stream each poll.
Changes since v6:
- Reverted back to dev_dbg instead of dev_err for the normal hpd case.
- Picked up Acked-by from Krzysztof Kozlowski from v6 on the bindings patch.
Link to v6: https://lore.kernel.org/all/[email protected]/
Rahul T R (2):
dt-bindings: display: bridge: cdns,mhdp8546: Add no-hpd property to
the cadence bridge
drm: bridge: cdns-mhdp8546: Add no-hpd property
.../display/bridge/cdns,mhdp8546.yaml | 11 +++ .../drm/bridge/cadence/cdns-mhdp8546-core.c | 69 +++++++++++++++++-- .../drm/bridge/cadence/cdns-mhdp8546-core.h | 1 + 3 files changed, 75 insertions(+), 6 deletions(-)
Signature · 1 line
2.34.1