Skip to content

RFC Add initial Raspberry Pi Pico 2 / RP2350 support

Bhargav Das u-boot 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest3 patches 15 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/3arm: Add RP2350 architecture supportarch/arm/Kconfig arch/arm/Makefile arch/arm/include/asm/arch-rp2xxx/rp2350.h +5 more+756 -01 reply
2/3arm: dts: Add RP2350 device treearch/arm/dts/Makefile arch/arm/dts/rp2350-pico2.dts arch/arm/dts/rp2350.dtsi+63 -01 reply
3/3board: raspberrypi: Add Pico 2 supportboard/raspberrypi/pico2/Kconfig board/raspberrypi/pico2/MAINTAINERS board/raspberrypi/pico2/Makefile +3 more+187 -01 reply

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [RFC PATCH 0/3] Add initial Raspberry Pi Pico 2 / RP2350 support

This series adds initial U-Boot support for the Raspberry Pi Pico 2 board and its RP2350 SoC, only the dual-core Cortex-M33 support is added.

Sent as an RFC to get feedback on the overall approach before polishing further.

Status as of this RFC:

- UART1 console works; UART0 is not usable yet. Need to investigate.
- Boot-tested on both Pico 2 and Pico 2 W boards.
- make sandbox_defconfig passes with patches applied.
- This series selects CPU_V7M for RP2350. RP2350's Cortex-M33 core is Armv8-M since there is no CPU_V8M support in U-Boot yet. Is CPU_V7M acceptable as a starting point with CPU_V8M as a later follow-up?
- RP2350 has no device tree in mainline Linux yet, so patch 2 hand-writes rp2350.dtsi / rp2350-pico2.dts locally, and rpi_pico2_defconfig uses CONFIG_OF_EMBED rather than CONFIG_OF_UPSTREAM.
- board/raspberrypi/pico2/ is added alongside the existing, unrelated BCM283x Raspberry Pi boards under board/raspberrypi/. Is this directory placement acceptable given the SoC is unrelated, or should it live elsewhere?
- Some functions and structures such as struct rp2350_clocks_regs is defined but not yet used.
- misc_init_r() sets a fixed value for the "serial#" environment variable. This runs after relocation, so a successful env_set() here confirms env works post-relocation.

Flashing procedure used for testing:

picotool uf2 convert u-boot.bin u-boot.uf2 --family rp2350-arm-s --offset 0x10000000 picotool load u-boot.uf2 -v -x

Bootlog:

    U-Boot 2026.04-rc3-00070-gbabf6d42fec7-dirty (Jun 23 2026 - 01:55:20 +0530)

    CPU:   Raspberry Pi RP2350
    Model: Raspberry Pi Pico 2
    DRAM:  520 KiB
    Core:  5 devices, 5 uclasses, devicetree: embed
    MMC:   
    Loading Environment from nowhere... OK
    In:    serial@40078000
    Out:   serial@40078000
    Err:   serial@40078000
    RP2350>

Bhargav Das (3):
arm: Add RP2350 architecture support
arm: dts: Add RP2350 device tree
board: raspberrypi: Add Pico 2 support

 arch/arm/Kconfig                          |   7 +
 arch/arm/Makefile                         |   2 +
 arch/arm/dts/Makefile                     |   1 +
 arch/arm/dts/rp2350-pico2.dts             |  30 +++
 arch/arm/dts/rp2350.dtsi                  |  32 +++
 arch/arm/include/asm/arch-rp2xxx/rp2350.h | 307 ++++++++++++++++++++++
 arch/arm/mach-rp2xxx/Kconfig              |  58 ++++
 arch/arm/mach-rp2xxx/Makefile             |   4 +
 arch/arm/mach-rp2xxx/image_def.S          |  23 ++
 arch/arm/mach-rp2xxx/rp2350.c             | 261 ++++++++++++++++++
 arch/arm/mach-rp2xxx/u-boot.lds           |  94 +++++++
 board/raspberrypi/pico2/Kconfig           |  15 ++
 board/raspberrypi/pico2/MAINTAINERS       |   9 +
 board/raspberrypi/pico2/Makefile          |   3 +
 board/raspberrypi/pico2/pico2.c           |  83 ++++++
 configs/rpi_pico2_defconfig               |  29 ++
 include/configs/rpi_pico2.h               |  48 ++++
 17 files changed, 1006 insertions(+)
 create mode 100644 arch/arm/dts/rp2350-pico2.dts
 create mode 100644 arch/arm/dts/rp2350.dtsi
 create mode 100644 arch/arm/include/asm/arch-rp2xxx/rp2350.h
 create mode 100644 arch/arm/mach-rp2xxx/Kconfig
 create mode 100644 arch/arm/mach-rp2xxx/Makefile
 create mode 100644 arch/arm/mach-rp2xxx/image_def.S
 create mode 100644 arch/arm/mach-rp2xxx/rp2350.c
 create mode 100644 arch/arm/mach-rp2xxx/u-boot.lds
 create mode 100644 board/raspberrypi/pico2/Kconfig
 create mode 100644 board/raspberrypi/pico2/MAINTAINERS
 create mode 100644 board/raspberrypi/pico2/Makefile
 create mode 100644 board/raspberrypi/pico2/pico2.c
 create mode 100644 configs/rpi_pico2_defconfig
 create mode 100644 include/configs/rpi_pico2.h
Signature · 1 line
2.43.0