add support for Firefly-RK3288 and Rayeager PX2 boards
Get series with b4
b4 am 142441781.gJtRx3FmLT@diegoVersions newest first · linked by author and title
- v4 Latest posting 2/20 of 3 patches 0 repliesNew
- v4 posting 1/20 of 3 patches 0 repliesSuperseded
Patches in v4 posting 2/2 No applies recorded yet
None of the 3 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v4 yet.
Cover letter [PATCH v4 0/3] add support for Firefly-RK3288 and Rayeager PX2 boards
Am Montag, 26. Januar 2015, 02:22:55 schrieb Heiko St?bner:
Quoted 9 lines
Am Sonntag, 25. Januar 2015, 21:39:33 schrieb FUKAUMI Naoki:
Quoted 4 lines
This series adds support for following Rockchip SoC based boards.
- Firefly, Firefly-RK3288 (both beta and mass production version)
- ChipSPARK, Rayeager PX2I've applied this series with Andy's Tested-by for the Rayeager board and my Tested-by for the Firefly.
Quoted 6 lines
One caveat, I had to remove the gmac node from the firefly dtsi, as the whole gmac series goes through the network tree, so the dtb won't compile either in my tree or arm-soc due to the missing core node.
I'll try to see if I can get the separate gmac node in when everything is combined in 3.20-rc1.
I've added the missing gmac config now to my dts-branch for 3.21 (or whatever it might get called), with the following patch:
----------- 8< ------------
From: Heiko Stuebner <[email protected]>
Date: Fri, 20 Feb 2015 01:31:57 +0100
Subject: [PATCH] ARM: dts: rockchip: enable gmac on rk3288-firefly
This was left out of the original firefly board definition due to the ethernet support going completely through the network tree, making the underlying nodes unavailable.
Now that everything is present enable the gmac on the firefly.
--- arch/arm/boot/dts/rk3288-firefly.dtsi | 16 ++++++++++++++++ 1 file changed, 16 insertions(+)
arch/arm/boot/dts/rk3288-firefly.dtsi +16 -0
@@ -179,6 +179,22 @@ status = "okay"; }; +&gmac { + assigned-clocks = <&cru SCLK_MAC>; + assigned-clock-parents = <&ext_gmac>; + clock_in_out = "input"; + pinctrl-names = "default"; + pinctrl-0 = <&rgmii_pins>, <&phy_rst>, <&phy_pmeb>, <&phy_int>; + phy-supply = <&vcc_lan>; + phy-mode = "rgmii"; + snps,reset-active-low; + snps,reset-delays-us = <0 10000 1000000>; + snps,reset-gpio = <&gpio4 8 GPIO_ACTIVE_LOW>; + tx_delay = <0x30>; + rx_delay = <0x10>; + status = "ok"; +}; + &hdmi { ddc-i2c-bus = <&i2c5>; status = "okay";
Signature · 1 line
2.1.4