Skip to content

efi_selftest: allow UEFI testing on MAIX

Sean Anderson u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest1 of 6 patches 0 repliesNew

1 of 6 patches is in this archive. The cover letter announces 6.

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
2/6configs: reduce stack size of Sipeed MAIX+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/6] efi_selftest: allow UEFI testing on MAIX
Quoted 38 lines · Heinrich Schuchardt

For RISC-V testing on real hardware the Sipeed MAIX boards provides an affordable solution.

UEFI testing fails on the MAIX BiT with Mic because the UEFI sub-system reserves 16 MiB for the stack though the board only has 8 MiB.

The first two patches make the size of the memory reserved for the stack customizable on all boards defaulting to 16 MiB.

The value on the the MAIX BiT with Mic is set to 1 MiB.

Missing default load addresses for the MAIX BiT with Mic are added.

The sysreset driver is fixed to output the full reset message.

The UEFI network and block device unit tests are only built if the configuration provides the prerequisites.

Heinrich Schuchardt (6):
efi_loader: use CONFIG_STACK_SIZE in the UEFI sub-system
configs: reduce stack size of Sipeed MAIX
riscv: load addresses for Sipeed MAIX
dm: sysreset: wait after reset message
efi_selftest: SNP test depends on network
efi_selftest: block device test requires CONFIG_DOS_PARTITION

 Kconfig                            | 10 ++++++++++
 arch/arm/Kconfig                   | 17 -----------------
 arch/microblaze/Kconfig            |  8 --------
 configs/sipeed_maix_bitm_defconfig |  1 +
 drivers/sysreset/sysreset-uclass.c |  1 +
 include/configs/sipeed-maix.h      |  9 +++++++++
 lib/efi_loader/efi_memory.c        |  2 +-
 lib/efi_selftest/Kconfig           |  2 ++
 lib/efi_selftest/Makefile          |  5 +++--
 9 files changed, 27 insertions(+), 28 deletions(-)
Quoted 2 lines

--
2.27.0

When testing this series, after completing the self test the board does not reset automatically, even after pressing a key. Here is an (abbreviated) log

=> bootefi selftest

Testing EFI API implementation

Number of tests to execute: 32

<snip>

Summary: 0 failures

Preparing for reset. Press any key...

And after this I need to manually reset the board. Running the reset command from within the U-Boot shell works fine. Is this intended behavior?

In addition, the self test changes the default terminal colors and does not change them back. This is most noticeable when using a terminal which does not default to white text on a black background. As an example, I have configured my terminal to use black text on a white background in [1]. However, once the test has completed, the terminal colors are not returned to their defaults [2]. (in this example, I manually reset the board). Is this expected behavior?

[1] https://imgur.com/AUuVLFI.png
[2] https://imgur.com/6YGtK9n.png

--Sean