: Add UUID command-line option
Status from this message: Applied. Thanks.
Get series with b4
b4 am [email protected]Versions newest first
Patches in v1 Applied
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/3 | : vmware backdoor interface fixhw/ | +8 | 4 replies | |
| 2/3 | : Add -uuid option to QemuMakefile.target configure monitor.c +1 more | +56 | 5 replies | |
| 3/3 | : Plumb qemu_uuid through to the VMware back doorhw/ | +39 | 0 replies |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [Qemu-devel] [PATCH 0/3]: Add UUID command-line option
All,
Attached is a three part patch series to implement a "-uuid" command-line
option to qemu. The original work for this was all done by Gleb Natapov; since there hadn't seemed to be any activity on this since June, I picked up his patches and ran with them (original posting:
http://www.archivum.info/[email protected]/2008-06/msg00167.html). These patches are basically the same as his, just cleaned up according to Anthony Liguori's feedback.
Gleb: I'm willing to do the additional work to get these patches included in Qemu proper; if you prefer to do it, that's fine too. I don't care either way, I would just like to see them go in.
Anthony: I've addressed all of your comments from the previous patch series except for one. I didn't remove most of the "#ifdef CONFIG_UUID" from the vl.c file. In the case where UUID is not compiled into qemu, I think it is much preferable to noisily complain that we don't understand the -uuid command-line option, rather than silently fail to set it.