RFC Add support for Freescale's 85xx and P1/P2xxx eSPI controller
Get series with b4
b4 am [email protected]Versions newest first
- v1 RFC Latest0 of 4 patches 0 repliesNew
Patches in v1 No applies recorded yet
None of the 4 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [U-Boot] [RFC] [PATCH 0/4] Add support for Freescale's 85xx and P1/P2xxx eSPI controller
Dear Can Aydin,
Quoted 15 lines
The reason this is an RFC is that unfortunately the hardware on these chips does not permit indefinite SPI transactions on a given chip select. A chip select is asserted only when a 'transaction length' has been passed to the controller. Once the number of characters specified in the transaction length have been transmitted, the controller decides that the 'frame' has ended and de-asserts the chip select after a defined delay. It is not possible to initiate a second transfer without re-initialising the command register, and hence clearing and re-asserting a chip select signal.
This patch set addresses the issue by defining a read/write function in the
spi_flash_internalAPI. Subsequent patches add the freescale eSPI driver and add support for it in the spansion driver and the P1/P2 board configuration header.
Quoted 6 lines
I'm pretty sure that there are better ways of doing this, especially if a driver model with support for driver quirks was implemented for instance. Until then however, I assume having some sort of ability to use the SPI controller on these boards would be better than not being able to do anything at all. If anyone has a better solution please feel free to comment.
Can the Chip Select Pins be used as GPIO? It might be simpler to do that than adding a speciality to common code.
Quoted 5 lines
mode change 100644 => 100755 drivers/mtd/spi/spansion.c mode change 100644 => 100755 drivers/mtd/spi/spi_flash.c mode change 100644 => 100755 drivers/mtd/spi/spi_flash_internal.hcreate mode 100755
drivers/spi/fsl_espi.c
create mode 100755include/fsl_espi.h
Having edited from W****** using Samba?
Make sure the file modes are and stay 644!
Without looking at the functionality I saw several coding style issues in the patch series:
+ if ( cmd_len&& cmd )
+ memcpy(buffer, cmd, cmd_len);
should be like "if (cmd_len && cmd)"
Similar space issues seem to happen all over your patches, examples:
+ for ( i = 0; i< size; i++)
+ return bus == 0&& cs< ESPI_MAX_CS_NUM;
+#define ESPI_COM_CS(x) ((x)<< 30)
You need to fix that globally...
Best Regards,
Reinhard
PS: you might want to wait and see if that patch in common code to fix a special hardware issue is welcome@all ;)