Skip to content

RFC Add support for Freescale's 85xx and P1/P2xxx eSPI controller

Can Aydin u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 RFC Latest0 of 4 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 4 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [RFC] [PATCH 0/4] Add support for Freescale's 85xx and P1/P2xxx eSPI controller
Quoted 11 lines
Quoted 5 lines

Can the Chip Select Pins be used as GPIO? It might be simpler to do that than
adding a speciality to common code.

True, a GPIO pin could be re-purposed to serve as chip select, but that would involve a soldering iron and a steady hand as the P1/P2xxRDB boards are reference design boards sold by a lot of third party vendors (including Denx if I'm not mistaken) this would detract from the ability to just plug u-boot in and run with it.

Quoted 4 lines

People could also choose to bitbang the SPI on their custom hardware but again I feel that might defeat the purpose and spirit of u-boot. (Then again, I'm new so don't quote me on that).

Quick followup, I may have misunderstood that question. The SPI pins can only be re-purposed as extra data pins for the SDHC. It's not possible to use them as GPIO.