Add basic clock and pinmux functions to the Tegra2
Get series with b4
b4 am [email protected]Versions newest first
- v4 Latest0 of 4 patches 0 repliesNew
Patches in v4 No applies recorded yet
None of the 4 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v4 yet.
Cover letter [U-Boot] [PATCH v4 0/4] Add basic clock and pinmux functions to the Tegra2
Le 30/08/2011 18:23, Simon Glass a ?crit :
Quoted 17 lines
This patch series adds basic clock and pinmux functions to the Tegra2, and modifies the ap20 and board code to use them.
Changes in v2:
- Removed use of bitfield access macros
- Now uses manual shifts and masksChanges in v3:
- Removed bitfield shift/mask macros and write these out manually
- Rebased to take account to new MMC patches
- Remove future time function
- No microsecond timing changes as I am unsure of the state of this in U-BootChanges in v4:
- Rebase against U-Boot master
- Remove future time function from header also
Quoted 5 lines
Simon Glass (4):
Tegra2: Add microsecond timer function
Tegra2: Add more clock support
Tegra2: Add additional pin multiplexing features
Tegra2: Use clock and pinmux functions to simplify code
Patch series applied to u-boot-arm/master, with manual fix of three empty lines at EOF in patches 1 through 3.
These empty lines and other whitespace errors can be found and fixed by the submitter before sending the patch to the list: just apply the patches to a local branch created at the intended commit where application will happen, i.e.:
git fetch u-boot
or
git fetch u-boot-arm
(assuming you have a remote nicknamed u-boot[-arm])
git checkout u-boot/master -b temp
or
git checkout u-boot-arm/master -b temp git am 0001-xxxxx git am 0002-xxxxx
(etc)
If any empty line or bad whitespace warning occurs, go back to your working branch, fix and regenerate the patch set, then go back to temp and reset it:
git checkout temp git reset --hard u-boot/master
or
git reset u-boot-arm/master
Then you can run the
git am 0001-xxxxx ...
again.
When the patches are sent, you can go back to your working branch and then do a
git branch -D temp
to remove the temporary branch.
Amicalement,
Signature · 1 line
Albert.