Skip to content

Add basic Tegra30 (T30) support

Stephen Warren u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest9 patches 0 repliesNew

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/9Tegra: T30: Add include files+0 -01 reply
2/9Tegra: T30: Add AVP (arm720t) files+0 -03 replies
3/9Tegra: T30: Add CPU (armv7) files+0 -01 reply
3/9Tegra: T30: Add CPU (armv7) files+0 -05 replies
4/9Tegra: T30: Add common Tegra30 CPU files+0 -00 replies
5/9Tegra: DT: Add preliminary device tree files for T30 Cardhu+0 -00 replies
6/9Tegra30: Add Cardhu board files+0 -00 replies
7/9Tegra30: Add config files (common and Cardhu)+0 -02 replies
8/9Tegra30: Add common pinmux config in board_early_init_f+0 -02 replies
8/9Tegra30: Add common pinmux config in board_early_init_f+0 -00 replies
9/9Tegra30: Enable Cardhu build (SPL)+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH 0/9] Add basic Tegra30 (T30) support
Quoted 7 lines · Tom Warren

This patch series adds basic (boot to cmd prompt) support for Tegra30. This is based on the Tegra20 SPL, which initializes the AVP (ARM7TDMI boot proc) first, then control is transferred to the CPU (A9 quad cluster). It is based on current u-boot-tegra/next.

Future patches will add support/drivers for MMC, USB, I2C, SPI, NAND, and other peripherals. The Cardhu T30 board is supported initially.

I tested this on my Cardhu. I did notice one bug - the fdt_load and fdt_high environment variables (from include/configs/tegra20-common-post.h before this patch-set at least) aren't updated with correct values for Tegra30.

I did try booting a kernel (after downloading it over serial) and that didn't work, but it's quite plausible that's as much a kernel issue as a U-Boot issue, so I won't worry about that for now.

I will have some comments on the other patches in the series.