Skip to content

Add mx6solo/mx6duallite support

Eric Nelson u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v3 Latest5 of 32 patches 0 repliesNew

5 of 32 patches are in this archive. The cover letter announces 32.

Patches in v3 No applies recorded yet

#Subject and filesSizeRepliesApplied
17/32imximage.cfg: run files through C preprocessor+0 -01 reply
21/32mx6q_4x_mt41j128.cfg: skip initiailizing non-existent memory+0 -00 replies
28/32mx6q_4x_mt41j128.cfg: add mx6 solo/duallite support+0 -01 reply
30/32mx6qsabrelite: change CONFIG_SYS_PROMPT+0 -00 replies
30/32mx6qsabrelite: change CONFIG_SYS_PROMPT+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v3 yet.

Read the v3 thread

Cover letter [U-Boot] [PATCH V3 00/32] Add mx6solo/mx6duallite support

Hi Troy,

Quoted 78 lines · Troy Kisky

This series goal is to add support for mx6solo and mx6duallite variants of mx6qsabrelite board. The new targets are called mx6ssabrelite and mx6dlsabrelite.

The 1st 16 patches perform cleanup on imximage

The final 2 patches add support for expressions to mkimage. If found not to be worth the effort, they can be omitted.

Troy Kisky (32):
imximage: check dcd_len as entries added
imximage: remove redundant setting of app_dest_ptr
imximage: move flash_offset check to common location
imximage: fix size of image to load.
imximage: delay setting of image size
imximage: change parameters to set_imx_hdr
imximage: make set_imx_hdr_v1/v2 easier to read
imximage: make header variable length
imximage: remove static imximage_version
imximage: prepare to move static variables to struct data_src
imximage: change parameters for set_dcd_val/set_imx_hdr
imximage: move set_imx_hdr to struct data_src
imximage: move set_dcd_val to struct data_src
imximage: enable word writes for version2 header
tools: add parse_helper file
imximage: use parse_helper functions
imximage.cfg: run files through C preprocessor mx6q_4x_mt41j128.cfg: use symbols instead of hardcoded constants mx6q_4x_mt41j128.cfg: add comments mx6q_4x_mt41j128.cfg: use ddr3 mode for reset mx6q_4x_mt41j128.cfg: skip initiailizing non-existent memory mx6q_4x_mt41j128.cfg: force ZQ calibration
mx6: soc: update get_cpu_rev and get_imx_type for mx6solo/sololite
mx6: use CONFIG_MX6 instead of CONFIG_MX6Q
imx-common: cpu: add imx_ddr_size
arch-mx6: add mx6dl_pins.h
mx6qsabrelite: add support for mx6 solo/duallite mx6q_4x_mt41j128.cfg: add mx6 solo/duallite support
Add boards for sabrelite variants mx6s(solo) and mx6dl(duallite)
mx6qsabrelite: change CONFIG_SYS_PROMPT
parse_helper: add expression evaluation
imx-mkimage.h: use base + offset syntax

  Makefile                                      |    3 +-
  arch/arm/cpu/armv7/mx6/soc.c                  |   32 +-
  arch/arm/imx-common/cpu.c                     |   66 +++-
  arch/arm/include/asm/arch-mx5/sys_proto.h     |   10 +-
  arch/arm/include/asm/arch-mx6/imx-mkimage.h   |  133 +++++++
  arch/arm/include/asm/arch-mx6/imx-regs.h      |    2 +
  arch/arm/include/asm/arch-mx6/mx6dl_pins.h    |  118 ++++++
  arch/arm/include/asm/arch-mx6/sys_proto.h     |   10 +-
  board/esg/ima3-mx53/imximage.cfg              |  120 +++---
  board/freescale/imx/ddr/mx6q_4x_mt41j128.cfg  |  425 ++++++++++++---------
  board/freescale/mx25pdk/imximage.cfg          |   77 ++--
  board/freescale/mx51evk/imximage.cfg          |  114 +++---
  board/freescale/mx53ard/imximage_dd3.cfg      |   83 +++--
  board/freescale/mx53evk/imximage.cfg          |   86 ++---
  board/freescale/mx53loco/imximage.cfg         |   83 +++--
  board/freescale/mx53smd/imximage.cfg          |   83 +++--
  board/freescale/mx6qarm2/imximage.cfg         |   88 ++---
  board/freescale/mx6qsabrelite/mx6qsabrelite.c |  235 +++---------
  board/freescale/mx6qsabrelite/pads.h          |  172 +++++++++
  board/genesi/mx51_efikamx/imximage_mx.cfg     |  132 +++----
  board/genesi/mx51_efikamx/imximage_sb.cfg     |  126 ++++---
  board/ttcontrol/vision2/imximage_hynix.cfg    |  295 ++++++++-------
  boards.cfg                                    |    4 +-
  drivers/gpio/mxc_gpio.c                       |    6 +-
  drivers/video/ipu_regs.h                      |    2 +-
  include/configs/mx6qarm2.h                    |    1 +
  include/configs/mx6qsabre_common.h            |    1 +
  include/configs/mx6qsabrelite.h               |    4 +-
  tools/Makefile                                |    2 +
  tools/imximage.c                              |  487 ++++++++++---------------
  tools/imximage.h                              |   39 +-
  tools/parse_helper.c                          |  325 +++++++++++++++++
  tools/parse_helper.h                          |   28 ++
  33 files changed, 2106 insertions(+), 1286 deletions(-)
Quoted 6 lines

create mode 100644 arch/arm/include/asm/arch-mx6/imx-mkimage.h create mode 100644 arch/arm/include/asm/arch-mx6/mx6dl_pins.h create mode 100644 board/freescale/mx6qsabrelite/pads.h create mode 100644 tools/parse_helper.c
create mode 100644 tools/parse_helper.h

There's clearly a lot going on in this patch set. Does it make sense to split this into parts that can be reviewed and checked separately?

It seems that there are
- bug fixes to imximage
- enhancements to imximage
- enhancements to build for imximage.cfg (CPP)
- core i.MX6 changes (cpu types, etc)
- rework of imximage.cfg files to use CPP
...

And there's that simple one changing the prompt we can probably get a quick ack/nak on ;)