Skip to content

ARM: kirkwood: Convert the mplcec4 board to pinctrl

Stefan Peter linux-arm-kernel 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 1 patch 0 repliesNew

Patches in v1 No applies recorded yet

The patch the cover letter announces is not in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/1] ARM: kirkwood: Convert the mplcec4 board to pinctrl

Hi Andrew

Am 19.11.2012 13:18, schrieb Andrew Lunn:

Quoted 5 lines

Humm..

Try enabling CONFIG_DEBUG_PINCTRL. It prints out a lot of debug as the driver loads.

This is what I get

kirkwood-pinctrl f1010000.pinctrl: try to register 50 pins ... pinctrl core: registered pin 0 (PIN0) on f1010000.pinctrl pinctrl core: registered pin 1 (PIN1) on f1010000.pinctrl
...
pinctrl core: registered pin 12 (PIN12) on f1010000.pinctrl pinctrl core: registered pin 13 (PIN13) on f1010000.pinctrl pinctrl core: registered pin 14 (PIN14) on f1010000.pinctrl pinctrl core: registered pin 15 (PIN15) on f1010000.pinctrl pinctrl core: registered pin 16 (PIN16) on f1010000.pinctrl pinctrl core: registered pin 17 (PIN17) on f1010000.pinctrl
...
pinctrl core: add 8 pinmux maps
pinctrl core: add 2 pinmux maps
pinctrl core: add 1 pinmux maps
kirkwood-pinctrl f1010000.pinctrl: unknown pin mmp13 pinctrl core: add 6 pinmux maps
pinctrl core: failed to register map default (5): invalid type given kirkwood-pinctrl f1010000.pinctrl: registered pinctrl driver

I tried to get behind the reason for the "unknown pin mpp13" hoping that the subsequent errors regarding the maps are related, but it may be faster asking for your opinion.

Regards

Stefan Peter

Signature · 2 lines
MPL AG, Switzerland                     http://www.mpl.ch
Tel. +41 (0)56 483 34 34          Fax: +41(0)56 493 30 20

Read the cover letter in its thread