ARM/dts: omap3: Add DT support for IGEP devices
Get series with b4
b4 am [email protected]Versions newest first
- v4 Latest0 of 3 patches 0 repliesNew
Patches in v4 No applies recorded yet
None of the 3 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v4 yet.
Cover letter [PATCH v4 0/3] ARM/dts: omap3: Add DT support for IGEP devices
Hi Javier,
Quoted 17 lines · Javier Martinez Canillas
IGEP technology devices are TI OMAP3 SoC based industrial embedded and computer-on-module boards. This patch-set adds initial device tree support for these devices.
The device trees allows to boot from an MMC and are working all the components that already have device tree support on OMAP3 SoCs:
- MMC/SD
- UARTs
- GPIO LEDs
- TWL4030 codec audio
- pinmux/pinconf pinctrlSome peripheral are still not working such as Flash storage and Ethernet but support for these will also be included once the OMAP GPMC device tree binding patches land on mainline.
Quoted 8 lines
This is a v4 of the patch-set that adds MMC mux pins setup and fixes a build issue due recent changes on
twl4030.dtsi.The patch-set is composed of the following patches:
[PATCH v4 1/3] ARM/dts: omap3: Add generic DT support for IGEP devices [PATCH v4 2/3] ARM/dts: omap3: Add support for IGEPv2 board [PATCH v4 3/3] ARM/dts: omap3: Add support for IGEP COM Module
I've just applied your series for 3.9 on top of 3.8-rc2 and had to update the Makefile that was different in the base you used. At the same time I updated the subjects to use "ARM: dts:" prefix to be compliant with the latest trend :-)
The patches are available here:git://git.kernel.org/pub/scm/linux/kernel/git/bcousson/linux-omap-dt.git for_3.9/dts
Regards,
Benoit