Skip to content

SERIAL: OMAP: Remove idle handling from driver

a0131647 linux-arm-kernel linux-omap 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 2 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 2 patches the cover letter announces are in this archive.

Reviews trailers per patch

PatchSourav Poddar
SeriesT-b

Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.

Read the v1 thread

Cover letter [RFC/RFT PATCH 0/2] SERIAL: OMAP: Remove idle handling from driver

Hi,

Quoted 7 lines · Santosh Shilimkar

OMAP UART IP needs manual idle modes based on state of the IP. Currently this is handled by the driver with function pointers implemented in platform code.

This however breaks in case of device tree because of missing idle handling.

Quoted 8 lines

The series tries to address the issue

Patches has been tested on OMAP4 and OMAP5 devices where the console slugishness was observed without idle mode handling. CPUIDLE and suspend tested ok on these devices.

Need help in testing on OMAP2, OMAP3 and AM3XXX devices.

Tested this series on omap3630 beagle board for:
1. Retention in idle and suspend.
2. Off mode in idle and suspend.

Quoted 13 lines

Santosh Shilimkar (2):
ARM: OMAP2+: hwmod-data: UART IP needs software control of sidle
modes
SERIAL: OMAP: Remove the idle handling from the driver

  arch/arm/mach-omap2/omap_hwmod_2xxx_ipblock_data.c |    3 ++
  arch/arm/mach-omap2/omap_hwmod_33xx_data.c         |    6 ++++
  arch/arm/mach-omap2/omap_hwmod_3xxx_data.c         |    4 +++
  arch/arm/mach-omap2/omap_hwmod_44xx_data.c         |    6 +++-
  arch/arm/mach-omap2/serial.c                       |   31 --------------------
  drivers/tty/serial/omap-serial.c                   |   23 ---------------
  6 files changed, 18 insertions(+), 55 deletions(-)