Skip to content

SERIAL: OMAP: Remove idle handling from driver

a0131647 linux-arm-kernel linux-omap 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest1 of 2 patches 0 repliesNew

1 of 2 patches is in this archive. The cover letter announces 2.

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
2/2SERIAL: OMAP: Remove the idle handling from the driver+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [RFC/RFT PATCH 0/2] SERIAL: OMAP: Remove idle handling from driver

Hi,

Quoted 19 lines · Felipe Balbi
Quoted 18 lines · Felipe Balbi
Quoted 17 lines · On Fri, Feb 15, 2013 at 06:33:58PM +0530, a0131647 wrote:

Hi,

Quoted 15 lines · Santosh Shilimkar

OMAP UART IP needs manual idle modes based on state of the IP. Currently this is handled by the driver with function pointers implemented in platform code.

This however breaks in case of device tree because of missing idle handling.

The series tries to address the issue

Patches has been tested on OMAP4 and OMAP5 devices where the console slugishness was observed without idle mode handling. CPUIDLE and suspend tested ok on these devices.

Need help in testing on OMAP2, OMAP3 and AM3XXX devices.

Quoted 9 lines
Quoted 6 lines
Quoted 5 lines

Tested this series on omap3630 beagle board for:
1. Retention in idle and suspend.
2. Off mode in idle and suspend.

try setting autosuspend_delay to -1

Also try DT boot and try to wakeup from echo mem> /sys/power/state by sending data through UART console.

Suspend/resume with dt is not functional with the current mainline.

~Sourav