Skip to content

SERIAL: OMAP: Remove idle handling from driver

Santosh Shilimkar linux-arm-kernel linux-omap 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 2 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 2 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [RFC/RFT PATCH 0/2] SERIAL: OMAP: Remove idle handling from driver
Quoted 25 lines · On Friday 15 February 2013 07:12 PM, a0131647 wrote:

Hi,

Quoted 23 lines · Felipe Balbi
Quoted 22 lines · Felipe Balbi
Quoted 21 lines · On Fri, Feb 15, 2013 at 06:33:58PM +0530, a0131647 wrote:

Hi,

Quoted 7 lines · Santosh Shilimkar

OMAP UART IP needs manual idle modes based on state of the IP. Currently this is handled by the driver with function pointers implemented in platform code.

This however breaks in case of device tree because of missing idle handling.

Quoted 8 lines

The series tries to address the issue

Patches has been tested on OMAP4 and OMAP5 devices where the console slugishness was observed without idle mode handling. CPUIDLE and suspend tested ok on these devices.

Need help in testing on OMAP2, OMAP3 and AM3XXX devices.

Tested this series on omap3630 beagle board for:
1. Retention in idle and suspend.
2. Off mode in idle and suspend.

Quoted 7 lines
Quoted 5 lines
Quoted 2 lines
Quoted 1 line

try setting autosuspend_delay to -1

Also try DT boot and try to wakeup from echo mem> /sys/power/state by sending data through UART console.

Suspend/resume with dt is not functional with the current mainline.

With DT, suspend driver itself are not getting registered. The patch is in Paul's queue [1]

regards,
Santosh

[1] https://patchwork-mail2.kernel.org/patch/2116671/